(800) 853-2651
SHOP NOW

Recent content by HMPuller

Yesterday's Tractor Forums
  1. H

    MMOGTA Opening Weekend April 28,29

    Well it's that time of the year again when we dust off all of our old iron and go out and compete for bragging rights. This year will be slightly different then in years past. New this year a stream lined dead wight pulling schedule. The first Dead weight Percentage Pull will be April 28 and the...
  2. H

    m hp estimate

    My going to figure you to be about 75-80 hp with that set up.
  3. H

    Bore on M Farmall

    A plain M block can only be bored to 4.25. A super M,400 or 450 block you can bore to 4.375 but you will need to do a small amount of hard blocking at the bottem of the cylinders.
  4. H

    pulling tractor

    I'm not quite sure where you are coming from with the whole Farmall M rear end thing but in my area that is primarily what guys use is Farmall M's. They hold up just fine if not better then Oliver's. Kinda sounds like someone is bashing Farmall's just a little bit? Maybe you should read back on...
  5. H

    John Deere A pulling hitch.

    Buy a Farmall it's much easier or even an Oliver.
  6. H

    Farmall clutch question

    Go with the 6 botten 12" disk and pressure plate from a 706,806,856,986. You will have to remove the center hub in the disk But it will bolt right up.
  7. H

    Super M cam grind

    Call Gary Baker.
  8. H

    need people to call for parts on farmall m

    Also try Jim Benjamin
  9. H

    Farmall M Puller For Sale

    Could you e- mail me some photos? Thank you.
  10. H

    Merry Christmas

    Merry Christmas from the MMOGTA. And a Happy New Year!
  11. H

    Best race fuel

    Turbo Blue is a very good fuel. VP will also do the job as well as Sunoco race fuel.
  12. H

    Denny's carb shop

    So you probably would not buy a stroker kit from them?
  13. H

    Denny's carb shop

    Why do a lot of people say to stay away from Denny's Cab shop? What are the problems guys are having with his products? I'm looking at his engine kits and just wanted some feed back. Thank you.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top