Recent content by HOFarmall

  1. H

    Farmall 460/560 rear wheel

    Original 8 spoke cast wheel center is 250 lbs.
  2. H

    400 Engine into M Farmall?

    Both flywheels should fit. If you use the 400 flywheel you will need a clutch disc for a Super M. The 400 pressure plate will work or one for a Super M will also work.
  3. H

    Farmall h transmission cover

    They are paper gasket material.
  4. H

    SPARK PLUGS

    I have had good results with NGK AB6 in the Molines. Used them in almost stock U to 800HDs.
  5. H

    Removing rust and crust from rims, tubes, tires

    Sand blasting is the best way to clean the rims. The tire beads clean up with a small grinder with a cup brush. Light pressure to remove the rust but not the rubber. The same for the tubes. Air them up tight and keep the brush pressure very light. Once you get the hang of it you can remove...
  6. H

    D ring

    Tractor Supply has them in 3/4" and 1".
  7. H

    600-800 Transmission

    Thanks guys, that is what I needed to know.
  8. H

    600-800 Transmission

    Are the 4 speed transmissions and rear differential used in 641 and 841 the same? Thanks.
  9. H

    39 M rear end for pulling

    The castings in the 39 and early 40s are lighter. The main housing,trans cover, axle housings and bell housing are all lighter than later models. All the internal parts are the same except the bearing between the input shaft and the upper trans shaft. Most early cases are cracked above the...
  10. H

    home made weights

    1 sq foot of 1" carbon steel weighs 40.8 lbs.
  11. H

    M gear

    Ruffly 7.75".
  12. H

    W-9 for sale

    I am always happy to see a piece of American history. 100 per cent original or full bore puller they still take you back to another time. Chances are that W9 would have gone to the crusher if not saved by pullers and no one would see it. Glad he saved it and takes it out for people to see.
  13. H

    Farmall Tube Manifold

    Dennys does not offer the tubular manifold for the Farmall M any more. Does any one know who made these for them or who sells them now? The one I have now has rusted through and would like to replace it with the same thing. Thanks
  14. H

    Oil pump tube

    I am rebuilding a 172 out of a 800. I need the seal or bushing that seals the oil pump tube to the block. Was hopeful there would be one in the gasket kit. Is there any common seal that would work? Thanks
  15. H

    Far all carburetor

    The number is on the inside of the venturi and is very small. Have to look hard to find it.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top