Recent content by hoghollow

  1. H

    Oliver 1650 Serial Number

    should be 1966 model
  2. H

    will 329 gas engine from 6600 work in 4020 gas

    329 gas engine into 1966 4020 gas? 4020 gas with hole in block but have good running 329 out of 6600 combine what do you need to put engine in 4020? I know engine is less cubes but tractor is used as chore tractor so smaller engine should not be problem Has anyone did this and what is entailed...
  3. H

    2003 f250 transmission heat up

    will check into this thanks do not want to damage rebuilt tranny
  4. H

    2003 f250 transmission heat up

    gauge went up to yellow line pulled over and let truck idle for 10 minutes and gauge went back down to normal where it runs with no trailer or load on truck. This is seperate cooler not run thru radiator.
  5. H

    2003 f250 transmission heat up

    New rebuilt transmission heats up at low speed with heavy pull. Have about 2 mile uphill pull thru town (30 mph) with 12000# of hay on trailer. The old transmission started heating up on this pull after several years of use it also started locking up torque converter when using reverse or low...
  6. H

    She's gone

    may the Lord be with you She is in a better place now
  7. H

    Susan update.

    The Lord is with both of you Prayers
  8. H

    Hoist malfunction ??? My F-600

    x2 on hose to tank on 1 way cylinder with bad seals been that way for 15 years works for me
  9. H

    First fire of the season.

    Yea started my outdoor burner today also. Everything started as should house set at 69 and hot water heater gets a break now
  10. H

    1655 wf king pin

    Checking 1655 over this morning and walked around front of tractor and noticed center king pin on wide front sticking out about 3-4 inches. Put jack under it and drove it back in. Had to pull the lock pin under tractor out to get it back in place. Have owned tractor 7 or 8 years never had front...
  11. H

    Plastic liner for manure spreader

    I have older Gehl manure spreader (made by knight manufaturing) The sides are steel and are getting pretty thin in some areas. I replaced the steel floor with new metal several years ago. The spreader works very good and I would like to line the sides with plastic sheets. Thinking 1/4 thick...
  12. H

    log splitter

    Cut for 3 households Have skidsteer mounted logsplitter Most wood is handled by hand the first time is when we throw it in outdoor woodburners. Cut most into 16 ft lengths and haul home with dump trailer Chunk it up using splitter to lift logs no bending over and running saw into dirt Once...
  13. H

    Ollie keeps saving us

    Curios how many hrs a day are you running it and what is fuel consumption? I have a PTO generator about like yours I bought used over the winter. I have not had to use it yet other than to run it every couple months to make sure it will work when needed' will be running mine with either 1650...
  14. H

    Did some digging this weekend

    In Wisconsin it would have to be approved by the county. Can not touch any thing to do with sewer without prior approvel and work has to be done by approved and certified company.

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top