(800) 853-2651
SHOP NOW

Recent content by Hougie

Yesterday's Tractor Forums
  1. H

    Case 930 diesel

    Hello So i ve got my $400 case 930 diesel up and running good. Been pulling around a 13ft disc to smooth out a campground area and am considering buying a rotary mower to tow around. I am curious about my pto speed. I have what i believe is a 1965 with the 6 speed. Is it 540 or is there a...
  2. H

    More case 930 diesel questions

    Hello again, i ve just returned from my road trip and got back ti working in the tractor. The valve is free, however it will not seal. I lubed it and spun it and tapped it and lubed it and tapped it to no avail. It doesnt seem to want to seal and keeps swallowing the lube from the exhaust port i...
  3. H

    More case 930 diesel questions

    Oh boy. That is probably the right thing to do but it sure sounds expensive for my $400 tractor.
  4. H

    More case 930 diesel questions

    number 3 exhaust valve is not fully closing, it is passing air during the compression stroke with both valves "closed". #5 is missing the spring seat for exhaust valve and #6 has a broke intake rubber oil seal. #5 is the one leaking oil or something out of the exhaust. Seems to have good...
  5. H

    More case 930 diesel questions

    I had my wife turn it over with a bar for me and i think a cylinder other than the puking one has a valve stuck open. Most of the exhaust ports let a little whisp of air out but one makes a lot of air like something is stuck open but i am not sure. Also after looking at the manual the intake...
  6. H

    More case 930 diesel questions

    So all of the rocker arms have a little slack in them when the valve is fully closed none of the valves or springs seen to move at all
  7. H

    More case 930 diesel questions

    I wiped it down with a rag, the rubber is broken from the vent on top and allowed some dirt in
  8. H

    More case 930 diesel questions

    I have not adjusted valves before, i do have the service manual but don t have any gauges i would imagine i need. The pop that i hear at a lower idle i think is this cylinder actually firing intermittently because of the slightly black smoke that comes out with the pop. Should i check valves...
  9. H

    More case 930 diesel questions

    Okay, i pulled everything but the injector. I m second guessing whether it is diesel or oil. It doesn t have a really strong diesel smell so it may be engine oil. All the valves seem to be moving properly for that cylinder, i noticed in the exhaust ports a couple other ports are slightly wet on...
  10. H

    More case 930 diesel questions

    would it be safe to assume the particular exhaust port that is leaking the fuel is the problem cylinder? I will pull the hood and injector and dig in a little further. Thanks for the tips
  11. H

    More case 930 diesel questions

    It is quite a bit of fluid, i will give it the sniff test. It had been sitting for an undetermined amount of time. Would be a shame if an injector was bad, it seems to run good otherwise. Edited. I gave it the sniff test and it does smell like diesel so your prognosis is probably correct. I...
  12. H

    More case 930 diesel questions

    Hello again So i got the tractor running with coolant in it now and ran it for longer today, I noticed it has a pop miss occasionally which make it smoke extra blue, Once i finally got it to shut off (which it didn't want to all the way, Had to stall it) i got off and noticed that one...
  13. H

    Case 930 hyd/trans oil

    Excellent! I picked up a couple pails, looks like i will need 20gal for transmission and hydraulics. This post was edited by Hougie on 05/06/2023 at 06:32 pm.
  14. H

    Case 930 hyd/trans oil

    Evening Well i got my scrap case 930 diesel running and its time to start adding fluids back in. I believe it to be a round fender 1965 by the ser# 82539. My understanding from researching is that after 1963ish they used hydraulic oil in both trans/hyd circuits instead of gear oil in trans...
  15. H

    Case 930 diesel started wiring

    Thanks for the picture, do you happen to know wire colors on your solenoid. I have a yellow on the S terminal, main battery and preheat are on big post and nothing on R terminal, my understanding was that terminal was for gas motors. I did get it ti turn over with key to tonight by holding the...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top