Recent content by HowieFHS

  1. S

    Prime-mover LD50 or(John Deere)

    What can you guys tell me about these loaders, i can't find much info on the net, i think they were bought out. I know it has 3 cylinder John deere diesel motor, other than that not much. Any ifo much appreciate Thanks Brent.
  2. H

    Pertronix ?

    Sorry then... yes, this the kit advertised on the link from this forum as part number 1247xtp6, Pertronix calls it an Ignitor module. Here is what they sent to me in an e-mail: I've attached an instruction sheet for a 6 volt positive ground system. The only time you would need the ballast...
  3. H

    Pertronix ?

    Should I put the ballast resistor in the lead wire (neg-)going to the coil primary? Did the full 6v smoke the round can coil that came with the kit? I wasn't able to get spark with resistor in circuit as originally wired to block. Is there another way to wire it?
  4. H

    Pertronix ?

    Thanks for the input everyone. The kit I have replaced the square can coil with a round one, and there is no cool down, it just will never fire again unless I change or clean the plugs. Guess it is back to the points. I suppose I"ve lost $150 worse ways...just can"t remember any right now
  5. H

    Pertronix ?

    Hello, Have Pertronix kit 1247xt on 9N (front mount, pos grnd). Have cruised the archive for hours late nights, am losing sleep over this. Problem: Tractor will run for 2 or 3 hours, will not get spark to start up again after this time. Details: plugs have much unburnt carbon on them; will start...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top