(800) 853-2651
SHOP NOW

Recent content by IH 1256

Yesterday's Tractor Forums
  1. I

    MF 124 Baler timing

    do you have the chain link count for knotter drive on 124 MF tia.
  2. I

    4400 combine

    Thanks again for all of your all?s help, checked clutch it requires.015 gap it was alright ended up being bearing needing to be slid back I ended up tightening everything up then tightening lock collar last after installing clutch.
  3. I

    4400 combine

    I wasn?t aware I needed too, the bearing sits in housing and is non adjustable and as far as I know I put all shims back like they where. It?s makes a howling noise not bad but noticeable when you engage separator so I guess need more shims obviously. How do you go about shimming it correctly I...
  4. I

    9220 getting diesel into motor oil

    Could be shaft seals on injection pump not familiar with engine but everything I?ve experienced doing that?s either lift pump or injection pump
  5. I

    4400 combine

    Just installed electromagnetic clutch back on 4400 John Deere combine after having it off to replace bearing on counter shaft and now head runs as soon as you engage separator any ideas on what I did wrong and could it damage clutch running it
  6. I

    1175 case wont go into reverse

    thanks for the reply, I'd say its probably in shift housing because the linkage goes up and down fine in the cab when disconnected from shaft on housing. I was hoping someone was going to tell me there was something else wrong but no such luck I guess. Thanks again for your time and advise.
  7. I

    1175 case wont go into reverse

    After messing with this thing some more I have finally got it to go in reverse but you really half to work with it more so than any other gear. I've let it roll forwards and backwards doesn't seem to help.
  8. I

    1175 case wont go into reverse

    I have a 1175 case that wont go into reverse but goes into all other gears and in hi/lo range. Ive removed the pin out of the yoke on linkage and it moves fine in cab. I was curious what all is involved in taking shift cover off top of transmission, looks like cab may need to be removed or...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top