Recent content by ih555

  1. I

    Plow Identification Help

    Sorry Paul I don't own the plow so I don't have any more pictures but I've seen a few of these 3 point plows I was just curious about the model number. Instead of a hollow tube across its back they have a solid square tube. They look large and heavy duty.
  2. I

    Plow Identification Help

    I have seen a few of these John Deere 3/16th larger size mounted plows with solid square shafts across the top and a rubber rear tire. Must be a little newer? What model number would this be? Thank you in advance for your reply.
  3. I
    Expired

    For sale Farmall 400 Gas Fuel Tank

    This is a nice gas fuel tank taken off of a Farmall 400 years ago. It was replaced with a large captivity tank. This tank is in good shape and has always been stored inside. Call Jason at 507-276-3285.
    $275.00
  4. I

    '71 JD 4020 won't start

    I went to start my 4020 today, it has not been started for awhile. It started for a few seconds and died. Now it won't start again, no dash lights, no power at all. The batteries are a little corroded but it has 12.7 volts at the starter. It is completely dead. Any ideas? Thank you in advance...
  5. I

    720 diesel electric start?

    A friend of mine has a nice original one in good shape for sale if you're looking for one. Call (507) 276-3285.
  6. I

    Thinking of winter...

    I'm thinking ahead to winter, trying to come up some ideas to run a generator on a 4020 tractor during a winter storm/power outage inside an insulated farm shop. It would of course run at a high pto speed and my thought is to run a vent pipe over the exhaust and out a window. Will the tractor...
  7. I

    New shop foundation? Poles in ground or out?

    I am researching foundation options for what is going to be a 40x64 insulated shop with a 16 ft sidewall. I'm looking into all different types of foundations, not just poles in the ground. I am located in Minnesota and would prefer not to have poles in the ground. I have heard many stories of...
  8. I

    Battery Tenders

    I'm looking to purchase two battery tenders for my 24 volt JD tractor. What amp works best? I'm looking at the Battery Tender brand, they recommend a 5 amp for a tractor. That seems like too many amps. I'm thinking the 1.25 amp might work or is that not enough? Has anyone had any experience with...
  9. I

    Battery tender on 24 volt system

    If you have a tractor with a 24 volt system, how do you go about putting a battery tender on....two tenders, one on each battery?? Has anyone had success doing this? Thank you for your help.
  10. I

    John Deere 3020 Diesel reving up

    Mine starts with JDB.
  11. I

    John Deere 3020 Diesel reving up

    It'a a roosa. Is the bolt below the throttle supposed to be adjustable? It seems I can only make it loose or tight, nothing in between
  12. I

    John Deere 3020 Diesel reving up

    I have a counsel 3020 diesel, was cutting hay a couple weeks ago and it worked fine, but at the end of the day, while idling, it wanted to rev up on its own. Today I tried starting it up, it was okay at first but after a bit, it started reving again, not sure if its a linkage problem, pump...
  13. I

    730 Front weights

    I have an extra set I could sell. Give me a call sometime (507) 276-3285.
  14. I

    Farmall Super H

    James, I have a nice 1954 Super H if you haven't found one. The tractor is all original and in very good condition. Give me a call (507) 276-3285. Thanks, Jason
  15. I

    looking for help with loader cylinder seals

    Carl, I am also from Minnesota. I have some cylinders off a farmhand loader that would fit your 70. Call me at (507) 276- 3285. Thanks, Jason
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top