(800) 853-2651
SHOP NOW

Recent content by IH560MAN

Yesterday's Tractor Forums
  1. I

    IH 560 Reuild

    So is it possible the wrong sleeves were put in? the serial number for this tractor stars with 26
  2. I

    IH 560 Reuild

    Never
  3. I

    IH 560 Reuild

    I apparently need to learn how to measure a crank with a micrometer better. I re did the measurements after a bit of schooling on how to read a micrometer and the crank is between 2.3635 and 2.3639. so, it appears that ordering -.010 bearings would be fine. As far as ordering new sleeves...
  4. I

    IH 560 Reuild

    Is that because the wear is so uneven?
  5. I

    560 rebuild...

    My 560 with the D282 recently started puking oil out of the blow by tube, I went to change the oil and filters and found large chunks of the piston sleeve in the oil pan. Now for the first time I am doing a in frame overhaul. After pulling the head it was obvious the sleeves were loose, they...
  6. I

    IH 560 Reuild

    My 560 with the D282 recently started puking oil out of the blow by tube, I went to change the oil and filters and found large chunks of the piston sleeve in the oil pan. Now for the first time I am doing a in frame overhaul. After pulling the head it was obvious the sleeves were loose, they...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top