(800) 853-2651
SHOP NOW

Recent content by IHdigemdepper

Yesterday's Tractor Forums
  1. I

    Super H starter weak

    You need to do a voltage drop on you system..ie volt meter pos lead on batt pos neg lead on solenoid at starter.No more than 250 milivolts drop.Also do neg lead same way,same results. By doing this you will eliminate all electrical systems main feeds.Start switch doesn't carry much amps as it...
  2. I

    Clutch headacke

    I have received some good replies but as I stated the manual for my machine doesn't show good pics of flywheel.Does anybody, by chance, have any good pics of the bare flywheel so I can see if my unit has a recessed area where the clutch disc fits into.Again my unit is a IH 2606 Industrial loader...
  3. I

    Clutch headacke

    If that were the problem I should have noticed some unusual goings on when I moved machine to where I was going to change the oil.It worked perfect.Then I changed oil restarted to check for any leaks & it began to rain so I left machine in that spot for at least 1 month as weather was rainy a...
  4. I

    Milky looking oil in Reverse-0-matic

    Milky oil is caused by 2 things...water/antifreeze in it or air.May have a suction leak to the pump where oil is drawn from causing air to enter oil & then getting pressurized.If air it will have to coming from the suction side only as pressure side will show a external leak somewhere.One other...
  5. I

    Clutch headacke

    No disc in correct as it has never been out since I have owned machine since 1977.TO Bearing moving correctly & is pushing PP fingers in more than enough to release disc.I also took all end play out of linkage to make sure I got as much release as I could on disc & still NG.Thanks for your reply...
  6. I

    Clutch headacke

    Ya this was what I was thinking as the couple of cars I worked on needed trans removed to get disc loosened.I was hoping I just missed something as unit worked no problem for 30 plus years since I bought it in 1977,until it sat for a few months.I didn't think it would have stuck that bad,that...
  7. I

    Clutch headacke

    I have a 66 IH Industrial loader/backhoe & after changing motor oil & sitting for 3 weeks the clutch would not disengage trans.Everything is working from pedal through throw-out bearing & when starter is removed you can see fingers of clutch releasing.My tractor doesn't have a TA set up just 5...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top