(800) 853-2651
SHOP NOW

Recent content by ilbdarned

Yesterday's Tractor Forums
  1. I

    Oil Filter Conversion Kit

    I like when others add to a thread no matter how old it is, because it makes the thread more informative having input from people with different experiences. Adding to a thread no matter how old it is, is contributing to the database so people reading it have more of a chance to find their...
  2. I

    Oil Filter Conversion Kit

    Yea but the responses here are for others with the same problem that looked up that same question and ended up here, I have got answers to problems others had asked 10 years ago.
  3. I

    Oil Filter Conversion Kit

    My Ford 3500 gasoline 3 cyl was built in 1972, the manual I bought was a copy of the old school original owners manual, it said the capacity was 8 quarts which assume is with the huge canister filter. It was was bought used and had a spin on filter, I assume somebody added the kit, my...
  4. I

    Oil Filter Conversion Kit

    My Ford 3500 Industrial had a spin on oil filter conversion when I bought it, the manual said it originally held 8 quarts. The dip stick says add at the bottom, then has a hash marked area and the word FULL stamped on the dip stick going up the stick. I read where people said with the...
  5. I

    Ford 3000 and 4000 series Tractor Power Steering Assist

  6. I

    Ford 3000 and 4000 series Tractor Power Steering Assist

  7. I

    Ford 3000 and 4000 series Tractor Power Steering Assist

    My instructions on rebuilding steering cylinder is below One more bit of info I learned the hard way, Do not use Harbor freight o-rings, they are not to spec and can be undersized so much they will not seal. I learned that the hard way. Get them at your local hardware store and mic them...
  8. I

    3400 Ford Transmission Bearing Source HELP HELP HELP

    I found a place that says they have the bearing. Just in case anyone that needs one thinks there isn't one anywhere in the world as you told them. It is called AHR international. This is their web page with the bearing number in the third column scroll down to the C5NN7133A...
  9. I

    Painting with John Deere brand paint

    Hardner I have used in the past if left in a mixing cup dries to a substance like rubber, It appears to make the paint more flexible not more hard. Not really sure why they call it hardener because the harder the paint, the more likely it is to crack or chip.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top