(800) 853-2651
SHOP NOW

Recent content by IntHarv

Yesterday's Tractor Forums
  1. I

    International Harv. 444 tractor

    I would suggest weights or fluid in the back tires though. Kind of a light tractor.
  2. I

    International Harv. 444 tractor

    I'd feel pretty comfortable putting a loader on it. The pic shows that its been done. The front ends are pretty tough on those 400 utilities. I have a 424 that I've thought about putting a loader on. Good power steering too!
  3. I

    424 charging issue

    when you put the negative on the battery pos and the pos on the generator all you are doing is getting the battery voltage. It may say -12.4 since you are reversed. You need to check the voltage coming off of the terminal of the generator that goes to the bat. Put pos on that pole and ground it...
  4. I

    310 Starter troubles

    Have a similar problem with my IH. It will click, click, click ... and then engage. Then there is times it starts first push. Gets annoying pretty fast. There is either just a bad place in the starter (its original like much of the tractor) or there is a bad ground somewhere.
  5. I

    IH 424D

    The underslung isnt much of a hazard but why not just send it through the top. You can get a pipe that screws into the manifold and clamp on a muffler. You just have to cut a hole in the top.
  6. I

    Looking for somethin new

    Looking to purchase a new tractor in the next year. Would like to have around 80 hp and doesnt really matter diesel or gas. Want something with multiple hyd remotes for future implements. Mostly haymaking and transporting duties. 4wd would be great as I have a lot of places it would come in...
  7. I

    Farmall 400 won't start.....+ ground??

    You can try connecting the bat - to + and + to - it shouldnt hurt anything but maybe spark a bit. Starter will run the same direction no matter what the polarity is. If it works then thats great! I would say if he had the battery in backwards like you said in the earlier post then its a good...
  8. I

    IH 424 Stuck in Reverse

    Great news! I took the pin out today and saw the miss aligned rail. I put it back in place and all is well! Thanks Bob!
  9. I

    Farmall 400 won't start

    You could also bypass everthing and apply jumpers to the starter itself. Make sure tractor battery is disconnected. Connect positive from jumper on the starters hot termial and negative on a chassis ground. The starter should engage and if nothing else is wrong it should start. As always out of...
  10. I

    424 surging when warm

    I had a similar problem with my 424 two years ago. It would run fine and then surge for a bit and finally die. I thought it had to do with being hot too. My problem was due to worn parts in the carb. It had sat for a while with no gas and the valve assembly rubber tip dried inside and was stuck...
  11. I

    IH 424 Stuck in Reverse

    Havent worked on it yet. Noticed the Farmall IH specific forum and was just getting all the ideas I can before I dig in. I will let you know how it turns out.
  12. I

    IH 424 Stuck in Reverse

    I have a IH 424 and was out mowin and was backing into a stall by the barn. When I went to pull out the engine died. Somehow the trans is stuck in reverse and I cant get it out. I am able to slip into 2 3 and 4 but when i let off the clutch the engine struggles and tries to quit. I can still...
  13. I

    IH 404 questions/problems

    I had a similar problem with my 424. It would run fine and then just die. My problem was due to worn parts in the carb. It had sat for a while with no gas and the valve assembly rubber tip dried inside and was stuck shut and wouldnt open to let fuel in. I figure if it was stuck up it would cause...
  14. I

    IH 424 Stuck in reverse

    I have a IH 424 and was out mowin and was backing into a stall by the barn. When I went to pull out the engine died. Somehow the trans is stuck in reverse and I cant get it out. I am able to slip into 2 3 and 4 but when i let off the clutch the engine struggles and tries to quit. I can still...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top