Recent content by IowaSam

  1. I

    Pequea 806 hay wagon driving me nuts

    air pressure-over inflated tires ? ?
  2. I

    Re: Honda Pressure Washer dies when chock rod is put in

    ? ? Full RPM ? @ idle is fuel flow.
  3. I

    over heating IH 5626

    Air flow or water flow. After we make hay, the radiator gets the garden hose ! ! Thermostat or water pump. I would drain, remove t stat, fill & test. Cheep & easy. I never met a W P that easy to replace !
  4. I

    ammeter vs voltage regulator

    I like having both on a Big dash,(like in the semi trucks I drove), on my old tracktors... It's - oil press, volts & temp,. & then hrs, rpm/speed. I don't trust idiot lights and/or their sending units!
  5. I

    52 8N Transmission Rebuild Question

    Yes, Step 1: Clean new bearings & trans shafts in mineral spirits, air dry till all odor is gone. Step 2: Put shafts in a plastic bag & into your freezer. Step 3:Place bearings on alum covered cookie sheet in your oven @ 350* for 30 minutes. Step 4: Assemble parts on kitchen table, clean-up &...
  6. I

    Removing stuck rings

    Liquid Wrench is my go to "juice" for rusted parts. I have freed 2 frozen motors, both took days of soaking before we tried pull starting them free. That said... Soak them in a 5 gal bucket w/ lid in some diesel @ $4+/gal, W D 40 @ $20+/gal, or L W @ $40+/gal. The next day try to pry and tap...
  7. I

    OT 2009 ram 3500

    JMHO, I would look for another brand/ company !
  8. I

    Hydraulic oil

    Add the 4++ gal of UTF Slowly! ! The port between trans & Dif is small, so to keep the proper amount of oil in the trans as the 3 pt is used when moving. There is a breather hole between the trans & clutch housing. Filling too fast won't hurt the clutch, & will drain out the weep hole, but that...
  9. I

    Skid for a poly tank

    250 gal x 8 lbs/gal = 2000 lbs. I'm sure those tanks came from the factory with mounting brackets for when loaded to capacity. Anything less will only result in a bad day for all. Google is your best friend, buy or build to OEM specs. Safety isn't cheap, but better than the cost of of an accident !
  10. I

    Skid for a poly tank

    250 gal x 8 lbs/gal = 2000 lbs. I'm sure those tanks came from the factory with mounting brackets for when loaded to capacity. Anything less will only result in a bad day for all. Google is your best friend, buy or build to OEM specs. Safety isn't cheap, but better than the cost of of an accident !
  11. I

    Carb rebuild questions.

    I have rebuilt many Marvel carbs, never one that had a bushing there. JMHO, they are a finicky bugger to any kind of air leak/imbalance, but are great when running right. I can not overly stress how important it is to have the right viscosity oil in the air cleaner for each "kind" of tractor...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top