(800) 853-2651
SHOP NOW

Recent content by iwanta3020guy

Yesterday's Tractor Forums
  1. I

    3020 24 volt

    Tx jim I see you here a lot. You should charge people for your knowledge. So if I had to charge the batteries you would have to charge them one at a time right? I never owned a tractor that had a 24volt system. I think im giving this to much thought like when I had to remove my injector pump
  2. I

    3020 24 volt

    ya, im new here, only my 3rd or 4th post. my tractor doesn't have any lights on the fenders. they were removed for the cab that the previous owner put on. Why would one positive terminal be grounded to the tractor frame on one battery and one negative terminal on the other battery be grounded...
  3. I

    3020 24 volt

    So I got my injector pump off and it is getting rebuilt. So while im waiting for it to get back I figured I would nose around and look under my cab and I find 2 batteries on both sides of the tractor, with the left side being hooked up positive ground and the left side hooked up negative ground...
  4. I

    3020 injection pump removal

    Does anyone know a better way to get the timing marks lined up on a injection pump for removal than cranking the engine over with the starter? I cant even come close to getting them lined up using this method. Thanks
  5. I

    injector pump rebuild

    Does anyone know a good shop to get a injection pump rebuilt in or around central PA?
  6. I

    3020 update and thx

    A big thanks to TimS and TxJim, I took the fitting out and it ran fine. I found a lot if small black stuff and some small white stuff.I cleaned it out and put it back together and it ran good for a few hours and the same thing happened again. Gonna take the pump off and get it rebuilt sometime...
  7. I

    John deere 3020 D stalls out

    no the pto shaft doesn't stay forward with the brush hog unhooked, you can still move it forward and back a little bit. I thought it was the injection pump also but the tractor will start and run for a few seconds but it dies out. this all happened the same time I was mowing and noticed the...
  8. I

    John deere 3020 D stalls out

    Hello, I really hope someone can answer this for me. If my brush hog jumped the pto hook up and pushed the tractor pto shaft forward could that have messed up the pto and engine clutches and cause the tractor to start but stall out after about 10 seconds?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top