Recent content by jackw

  1. J

    CaseIH 5140 hard shifting

    The only other issue I have had with this tractor was the fuel system losing prime. Contacted the local dealer and a couple of mechanic friends about this. The dealer said probably the line from tank to pump was cracked and I would have to remove the left rear wheel and drop the fuel tank down...
  2. J

    CaseIH 5140 hard shifting

    Yeah hopefully it isn't too expensive to fix. Don't have a lot of extra cash right now.
  3. J

    CaseIH 5140 hard shifting

    Thanks for the info.
  4. J

    CaseIH 5140 hard shifting

    If I shift the range side into gear and leave the other lever in neutral I can start the tractor and put it in gear with no grinding and I'm good to go. I can also shift the range from 3rd to 4th without any grinding. It's mainly when starting the tractor when cold as in the oil temp not...
  5. J

    CaseIH 5140 hard shifting

    I have the synchromesh transmission not the powershift. Sometimes I wish I had the powershift. Thanks for the info.
  6. J

    CaseIH 5140 hard shifting

    I don't have a neutral in the shuttle. Hopefully all it needs is some adjustment. Thanks for the info.
  7. J

    CaseIH 5140 hard shifting

    Shifting faster does not work it grinds too much. It isn't hard to shift out of gear just going in. Hopefully it's an adjustment issue. Thanks for the info.
  8. J

    CaseIH 5140 hard shifting

    That's what I have is the synchromesh transmission and it grinds pretty good in the range side. It gets better after it warms up. Hopefully it just needs some adjustment. Thanks
  9. J

    CaseIH 5140 hard shifting

    I have a 1991 CIH 5140 Maxxum MFD with manual transmission (not power shift) that shifts hard especially when cold. It grinds going into gear on the lever with the Roman numerals (can't remember what that's called). I shut the engine off and then shift into gear start the engine and then shift...
  10. J

    Hydraulic problems

    About 18-20 months ago I posted a problem I was having with my model 640 tractor. I was using a 5' rotary mower and after raising and lowering it several times I noticed oil coming out of the shift lever. I was told at the time that there are 2 hydraulic lines that run through the transmission...
  11. J

    Hydraulic problems

    Thanks, I will give it a try.
  12. J

    Hydraulic problems

    About 18-20 months ago I posted a question about a hydraulic problem I was having. I was using a 5" rotary mower and after raising and lowering it a few times I noticed oil coming out if the shift lever. I guess I should mention that the tractor is a 600 or 601 with a two point hitch and one...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top