Recent content by Jamelia

  1. J

    Bleed fuel after filter change question MF 135

    Gravity bled, then loosened lower bolt on the injector pump and cranked for about 10 sec, then repeated with upper bolt, then loosened line going to injectors and cranked for 10-15 sec and it started, woo hoo!! Now I get to do it all again, I dropped the filter when it came off and cracked the...
  2. J

    Bleed fuel after filter change question MF 135

    I am getting ready to change my fuel filters for the first time, and I see my primary pump has no manual pump on it. The manual shows what looks like the same pump, but mine has no way to manually prime it. If I have my wife sit by the key, and she turns the starter, will this have the same effect??
  3. J

    Shear pin on snowblower

    Update!! So the unthinkable happened, one of the tire chains came off in a bog drift, and lodged in the auger. Yes, the photo shows the shear pin, 2 of them, and they both broke, and the chain snapped. Today I replaced the shear pins with bolts, I went to 2 tractor dealers and they had no shear...
  4. J

    Hydraulic issue help requested

    So, for my final post, everything works perfect!! When I used the snowblower and raised it to drive, it would lift all the way and start to chatter. Now with the levers in their proper position, the blower lifts about a foot and stays there. The bucket works when and where I want it to, every...
  5. J

    Hydraulic issue help requested

    Trying from my phone. File size is very small now
  6. J

    Hydraulic issue help requested

    Trying photos cropped
  7. J

    Hydraulic issue help requested

    That is an extremely helpful reply. On the two handled valve you are talking about (I think, geez I’ll be glad when I can post pics), and is on the right side of the drivers seat the outside lever moves the blower up or down. I never knew what the inside one did. The two handled valve beside...
  8. J

    Hydraulic issue help requested

    Yes, up is for the bucket, down is for the blower
  9. J

    Hydraulic issue help requested

    Photos didn’t come through. I’ll try here Nope, guess I can’t post photos
  10. J

    Hydraulic issue help requested

    I bought a MF135 a few years ago to blow snow on our road, the road is about 1/3 km long. The blower works perfect. The bucket on the front works intermittantly, and I need to lift it before I can drive. When it sits for a week the bucket will go down to the ground. Is the valve (I’m guessing...
  11. J

    Shear pin on snowblower

    Ok, well that stinks!! How would I go about putting one in? Sorry I am such a newbie with this! I just want to blow snow!!
  12. J

    Shear pin on snowblower

    How would I know if I have a slip clutch? I know its 2 stage, half out works the hydraulics, all the way out works the transmission.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top