(800) 853-2651
SHOP NOW

Recent content by James Lee

Yesterday's Tractor Forums
  1. H

    135 Massey Ferguson gas

    I am thinking about buying a Massey Ferguson 135 with the Perkins gas engine. Does anybody know how long these gas engines last.The tak says it has 2200 hours. The engine seems fine and every thing works well. He wants 3800 for it. How much would it cost to go to a shop and have the engine...
  2. Stroby

    JD 430W

    I have a 1959 430W that has "one" spring (left side when standing behind) to return the 3pt lift arms the lower position. It has the dual TOM, but the arms are pinned together. There is provision for the second spring (on the right side) but none exists. The owner manual has pictures of one...
  3. J

    Points vs EI

    Rick, just make sure you put the red and black wires through the right hole on the top plate, and push it in a little through the grommit to put a little pressure on it so the wires lay up against the wall of the dist. like the drawing shows. If they are in there loose, it is possible the wires...
  4. J

    Points vs EI

    I got the complete kit from this site, every thing including coil comes with it except the rotor button, don't know why, but if you get the kit, make sure you order a new rotor button. Easy to install, some of it is all ready done. James Lee = TN
  5. J

    Points vs EI

    Tractor is 12 volts, got the right set of blue streak points from this site, I did lube the cam shaft. I think I am going to like the EI James Lee - TN
  6. J

    Points vs EI

    I had posted earlier about my points loosing their gap in just a day or two. Ordered new stuff from YT. The stationary point plate had to have its holes reamed out and elongated before I could get my gap. Got my gap, tractor ran,but I forgot to put the pin in the movable points, did that, put...
  7. J

    points

    Thanks, every body, after looking at my points and the ones they sell at YT, there is a big difference where the movable point arm comes in contact with the lobe on the dist. shaft. The ones sold here look thicker and wider, with may be a wiper of some kind, mine were just straight and dry as a...
  8. J

    points

    Thanks, every body, after looking at my points and the ones they sell at YT, there is a big difference where the movable point arm comes in contact with the lobe on the dist. shaft. The ones sold here look thicker and wider, with may be a wiper of some kind, mine were just straight and dry as a...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top