(800) 853-2651
SHOP NOW

Recent content by James Marsh

Yesterday's Tractor Forums
  1. J

    eletronic ignition/ info needed

    I installed a Pertronix on a Ferguson 35 and it worked fine until.... After a heavy snowfall, I started the tractor to let it warm before moving some snow. I let it run while I did some other chores. After one half hour or so I noticed the tractor was no longer running. I thought maybe iceing as...
  2. J

    6 volt Battery Tender with 8 volt battery

    Each cell of a lead/acid battery should produce 1.1 to 1.2 volts. If an 8 volt battery only produces 8 volts or slightly less it is considered discharged. You cannot maintain an 8 volt battery at 6 volts, therefore, you need an 8 volt charger, minimum. Jim
  3. J

    Sickle Mower help

    Gregm, I have an original Allis-Chalmers Operating Instructions and Repair Parts Illustrations for the Model No. 3 Power Mower. I used to have a No. 3 set up for an Allis C. Contact me if you are interested.
  4. J

    Hydraulic problems for an H

    Fuller, you did not specify the model of loader you have on the "H". I have a McCormick-Deering Power Loader, No. 30. I also have the Owners Manual for Setting Up and Parts List. I no longer have the H, but, I do have the hydraulic hose assembly and return plumbing assembly. Contact me if you...
  5. J

    Farmall A Rim Color

    I did some research in the past regarding rim color and paint for a Farmall H and I found the original rims were plated with cadmium, a common plating material for corrosion prevention in those days. Don't think that would be possible now a days.
  6. J

    AC-B plow

    I have a "C" model that was rigged up for the same setup. The B should be able to handle a 16" plow. The two plows are used to throw the furrow in one direction (usually uphill) to counter the natural action of soil to move downhill. The tractor should have a split rockshaft, two hydraulic...
  7. J

    Farmall 560D batteries

    The 60 series wiring shows two six volt batteries wired in series to produce twelve volts. This same scheme was used in the John Deere 50, 60, and 70 tractors using rather large batteries. The JD's could accomodate a large (1200 CCA) 12V battery in the battery compartment (under the seat...
  8. J

    Help identify this A-C 2-14 trip plow

    I have the same model on steel. Bought it from an Allis dealer in Southern Maryland. You will notice in the photo it has a long landside which should bear against the furrow wall to provide lateral stability, (so I have been told).
  9. J

    TO-35 Starting Issue

    The comment about using the opposite hand on the choke knob and the starter button sounds like someone has replaced the ignition switch and also swapped the position of the starter button and the ign. switch. My factory operator's manual show's the starter button on the left for both the 35...
  10. J

    Check out this beautiful allis chalmers!!! Just completed!

    I am curious about the seat. I have a 1949 C and it came equipped with the wide bench seat.
  11. J

    A.C. cornplanter mounting

    I have an original dealers parts catalog for REAR MOUNTED DRILL PLANTERS dated June 1964. It contains info for the B, C, CA, WD, WD-45, D-10, D-12, etc. Give me a call and I will let you borrow it to copy. 405-567-0723. Jim
  12. J

    TO-35 Tuneup Question

    Re condensor, I had a JD 50 that suddenly failed to start just minutes after shutting down. Checked a bunch of stuff with no results. Final step was to change condensor, tractor started just like it always had.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top