(800) 853-2651
SHOP NOW

Recent content by James Oliverman

Yesterday's Tractor Forums
  1. J

    spitz did you find your 4-270 White parts

    Did you find the parts you needed? Where are you located? If not, I am interested in helping you keep the tractor going. Part numbers you need? Let me know!
  2. J

    Oliver 770 cuts out

    Check the condensor and coil. A lot of times it can seem like a fuel problem and will be electric.
  3. J

    4-270 parts

    Just rebuilt my transmission in my 4-270. There were updates on the transmission so be carefull when buying parts and installing them. Parts are hard to come by. I have had parts made for it as well. Here are some numbers of people who helped me with my 4-270. Try Tom at McFarlane Imp. He had...
  4. J

    4-270 White

    Where is the one located in the salvage yard?
  5. J

    Super 55 steering lube.

    Go to your local John Deere Dealer and ask the parts man for cornhead grease and they will have it.
  6. J

    Anyone have spare parts for an Oliver 566 plow?

    The plow you have could be a 575. I have a nice 6 bottom plow I would part out or sell whole. Call me at 920-210-3053.
  7. J

    over/under input shaft

    Call 920-526-9915 for all your Oliver and White parts needs.
  8. J

    Re: White 125 Workhorse auction

    telephone, telewoman, televeryone!!!! thanks!!!!!!!!!
  9. J

    White 4-270

    What is the condition of the unit? Can you go look for me and call me at 920-210-3053.
  10. J

    White 140

    I have the 145 Workhorse the cabs are different but most of the tractor is the same. Most of the parts I need I can still get from my local dealer if I don't have them myself. I was hoping someone new where there was one salvaged. It is the tractor from Mowrey Auction.
  11. J

    White 140

    Looking for wide front end parts and side panels for a 140 White tractor. Anyone know where there is salvage tractor at?
  12. J

    Oliver 1950 GM Industrial Hitch

    I measured my drawbar and it is 3 1/2 inches wide, 2 inches thick, and about 42 inches long.
  13. J

    Oliver 1950 GM Industrial Hitch

    I have a 2 105 Oliver Industrial tractor in the shop right now. It is built like a tank. Most parts for industrial Oliver's are not found. I have had experience with most models.
  14. J

    White 2-105 pulling

    I pulled my 2-105 at the local fair, it was to heavy to compete.
  15. J

    Oliver 1950 GM Industrial Hitch

    The drawbar on a 1950 Industrial is almost as big on my 4-270 White. I would say it would need to be custom made.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top