(800) 853-2651
SHOP NOW

Recent content by James Ross

Yesterday's Tractor Forums
  1. O

    D47u pony motor

    Dose anyone sell parts and gasket set for a D47u Pony motor
  2. F

    585 block heater

    Hi guys,i was wondering what the best way to go is for a block heater on my 585, Thanks,Rock
  3. B

    JD m carburetor

    Hello fellow green machine people. Been running this 51 M for almost 30 yrs now, or should i say trying to keep it running. I was Dean G over at the other green site. Had a leaking/dripping carb so pulled it off and checked everything out got it back on and no leaks now. I know, should have...
  4. J

    JD 40 Clutch

    Ok guys the 40 is back together, I adjusted the pressure plate just as the service bulletin said. I adjusted the clutch with one inch travel before the throw out bearing makes contact Sounds good doesn?t it. No No No. It works but I have a very short travel on the clutch pedal from engaged...
  5. T

    Farmall 14

    My 14 hasn't been started since last fall. Fired right up on about the 45th pull. Seems to be able to sense when my strength is just about gone. Put new tires on the front of the WD, and now one of them is flat.
  6. showcrop

    Two for One

    I have been fighting wood chucks here for a long time, but maybe the tide is finally changing. They have been in the foundations of the old henhouse and my 1700s post and beam barn. I can't use bombs because the smoke comes out between the rocks. The main entrance for the barn den is...
  7. B

    1955 310 pencil injectors.

    Replacing a leaking rear crank oil seal turned into a complete engine rebuild. 7000 hrs on this engine. Crank needs a grind.Head needs a valve job. sleeves and pistons show no wear. rod bolts still have the hex style heads and pin bushings are the split bushings(they will be upgraded)...
  8. S

    3020 and F130

    This plow has better trash clearance than my IH 314
  9. W

    trsting condenser

    New points , condenser, changed coil to non resistor required after old ballast failed. Today after only three hours use points burnt turning contact arm blue. Thinking poor condenser. What is the opinion of others and how would I test condenser?
  10. B

    Paint color info

    Here is some paint color info that I found the other day at my local dealer. I understand that the vendor is Valspar. Hope this helps.
  11. R

    More Pie Weight Comparison

    The white set (actually Ford light gray, but for the sake of simplicity) is what I believe are commonly referred to as the heavy AG set. Each pie segment weighs 42 lbs. Measurements in the pictures. The other set is what I believe are commonly called the heavy "industrial" style. Each...
  12. K

    Howdy from Texas

    Just bought this 9n this past week and have run across a few issues I tinkered with today. It appears to have an 8N engine on a 9N chassis. I spent the morning cleaning the fuel system as it has a sputter in all rpm ranges. It runs fine and cuts really good. I test drove it Friday at the guys...
  13. kcm.MN

    Sunday Tractor Pic

    1971 International 454 1973 International 574
  14. O

    Stuck lug nut

    I have an aluminum wheel on the Dodge truck the chrome cover came off the Lugnuts and the Lugnut got stripped I tried pounding a socket on it but nothing will break it loose now it?s round off recessed in the wheel any suggestions on how to get the Lugnut out of there I think they make...
  15. J

    screen filter on 6220 john deere

    changing transhydraulic fluid on tractor found 2 drain plugs and the 2 filters but cant find the screen filter they are talking about in the manual
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top