(800) 853-2651
SHOP NOW

Recent content by james06

Yesterday's Tractor Forums
  1. J

    Wheel nuts on Farmall H

    How do you loosen the nuts on the rear wheels on a farmall H? I have used WD40, Mouse Milk and liquid wrench to no avail. I have used impact wrenches and 1/2 inch socket with a 4ft bar. Should I use heat on the nuts or just cut them off?
  2. J

    IH model H, won't start

    Yes, I took the carb completely and soaked it carb cleaner for two days. If I spray gas into the intake it will start and run as long as I keep spraying gas into the intake.
  3. J

    IH model H, won't start

    The stream looks like about the same amount that the float valve lets in.
  4. J

    IH model H, won't start

    I will check it again, thanks
  5. J

    IH model H, won't start

    Thanks, I will give these adjustments a try
  6. J

    IH model H, won't start

    Yes. the plugs are dry. What I don't understand is that when you turn the tractor over with full choke gas does not run out from being over choked.
  7. J

    IH model H, won't start

    The H I have has been setting a couple years without being started or turned over with the crank. Did the diesel and atf mixture in the cyl for about a week and freed it up. Now the engine will not start. A squirt of starting fluid will make it fire for about 3 seconds and then quits. Had the...
  8. J

    stuck engine, farmall H

    Thanks for the tip. When I had the tractor outside I took the starter off to get it rebuilt. I stuck a towel in the starter hole to keep the dirt out. A few days later I went out to pull the tractor in the shop, I noticed that the towel was missing. I thought to myself that a squirrel must have...
  9. J

    stuck engine, farmall H

    I drained out the oil in the pan. Is there supposed to be oil somewhere else? I have not pulled the rod caps yet.
  10. J

    stuck engine, farmall H

    Yes, I pulled the starter off and it was not stuck in the ring gear/
  11. J

    stuck engine, farmall H

    Made a mixture of automatic trans oil and diesel fuel and squirted in each cylinder, after about four days it broke loose. Turned it over several times during the next few days. tried to start it and it fired a couple of times and stuck solid. Tried to turn the engine backward but wouldn't...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top