(800) 853-2651
SHOP NOW

Recent content by Jasondr

Yesterday's Tractor Forums
  1. J

    1566 won't start, even with ether

    Well we figured it out. With all the cranking the hydraulic clutch was pumped up to pressure so we were able to pull it. Started pulling it and in about 15' it fired up. Then it went wild. Started running away, the thottle did nothing, was running way over the governer. Probably 4000 rpm or...
  2. J

    1566 won't start, even with ether

    We put some lube down the injector holes then dropped the pan and put a board on a bearing throw and jacked it up
  3. J

    1566 won't start, even with ether

    First thanks for all your time thinking about this thing, i really appreciate it. We had penetrating oil down the injector holes to get it loosened up then cranked it over to blow it out, then squirted motor oil to lube and help with compression. It cranks over good for about five seconds then...
  4. J

    1566 won't start, even with ether

    No, we have the intake tube right off. Spraying ether right into the manifold. Can you even pull start these? I think it has a hydraulic clutch. I know I can't pull my 1086 but being my neighbors tractor I don't know as much about this one I'd assume its the same as mine.
  5. J

    1566 won't start, even with ether

    It should fire with ether with no fuel at all or the fuel shut off shouldn't it? If its valves sticking it must be a lot of them or I'd think it would try to run at least.
  6. J

    1566 won't start, even with ether

    I guess it was running when they parked it all we took off is the starter to be rebuilt, and the intake hoses and the stack. We had the injectors out and put a couple squirts of oil in the cylinders so I'm ASSUMING, its not a ring problem. But it still won't even fire on ether and we have...
  7. J

    Salvage

    Thanks
  8. J

    Salvage

    Thanks, I called him a few days back but he didn't have anything
  9. J

    Salvage

    I'll have to check that out. Thanks
  10. J

    Salvage

    I'm looking for a wide front for a 504. Does anyone know of a salvage yard for internationals around the central or metro Minnesota? Any help would be greatly appreciated. Thanks.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top