(800) 853-2651
SHOP NOW

Recent content by JasonLC

Yesterday's Tractor Forums
  1. S

    1983 MF240 front drive axle

    Hi, I have a 1983 MF240 with a 4WD conversion. It is a Coventry, England made tractor. I have broken the front left drive axle. It is a short axle with a yolk and spline. I am told it is probably a Schindler conversion. I have spent a few years now trying to track one down with no luck...
  2. 2

    Loading car on dovetail trailer - Help

    Neighbor boys Saturn car is disabled across the state of WI. I have a PJ deck over dovetail trailer I use for hauling my tractors. Is there any clever way to load that car on this trailer? I can only think of some form of a 2x12" plank arrangement to teeter the rear of the car up once the...
  3. jon f mn

    Todays funny

    .
  4. K

    w d

    have a w d. right side of axle, where drop axle drops. whew ?. there are about 8 bolts holding the drop axle housing. 4 of lower bolts are broken off or they are loose. 2 bolts are broken off deep within. will 2 bolts (on the bottom) hold this assembly? top bolts are all in place.
  5. H

    Tafe 45DI injector pump problems

    This message is a reply to an archived post by Michael Mac on July 30, 2012 at 17:55:53. The original subject was "Tafe 45DI injector pump problems". I have been trying to find somewhere to send a mico labosch injector pump off to have it built. It's off of a Tafe 45DI. I have had no luck...
  6. IFF

    MF285 High Speed Miss?

    I recently finishing up an inframe rebuild of the Perkins 4.318 in my MF285. It was rebuilt because I lost power and was blowing heavy black smoke. While the tractor was running in temperature range, the exhaust manifold got hot enough to discolor the cowl. Compression was low (360)...
  7. G

    Nascar Car Ride-Drive

    Hello, Did any of you take one? I think any gear head should take one. I'm thinking this is my year. There are ride along, or u drive. I choose the u drive one. Now I need to do some research.If all goes well, I am doing the ride before this summer, Guido.
    • guido
    • Post #1
    • Forum: Tool Talk
  8. J

    IH 684 add hydraulic rear remotes

    I know it has a draft control handle but I haven't removed the seat or anything to look for pipe #39. Thanks again for all your help Jim.
  9. J

    IH 684 add hydraulic rear remotes

    Yes very helpful Jim. You were correct I was calling the MCV the hydraulic pump. Now I have a clearer picture. I need to remove the seat and will gain access to the hoses where I need to connect. My next question was going to be about the valves but you already answered it. I need to get...
  10. J

    IH 684 add hydraulic rear remotes

    Thank you Jim. Very helpful. Do you know if I am correct to assume I can get pressure from the plug on the pump assembly? There is a hose connect directly beside it that looks to have the same size fitting as what would replace the plug? In the diagram it says to connect to the elbow on #38...
  11. J

    lift cover housing

    also, I had a service guy tell me that I can connect to the hydraulic flow at a banjo fitting on top of the lift cover housing. Does anyone know exactly where that might be? Can you tell me how to identify a banjo fitting?
  12. J

    lift cover housing

    Where is the "lift cover housing" on an IH 684 tractor? Does anyone have a picture of this? >Thanks!
  13. J

    IH 684 add hydraulic rear remotes

    I want to add rear hydraulic hookups on my IH 684 tractor. Right now it has no hydraulic function outside the transmission and power steering. I see a plug on the side of the hydraulic pump assembly that I assume will be a pressure point where I can connect my hoses to. What I don"t know is...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top