-
J
1020 Hydraulics
Any pictures of where this gauge would go to check pressure? There is also a lever on the side of the trans under the seat with a "D", "LD", and "L". what is that for? Also a selector valve? with a forward, neutral, and rear. Is that for the remote rear hydraulic? The loader arms only work...- Jbuys62
- Post #9
- Forum: John Deere
-
J
1020 Hydraulics
I let it cool down and fired it up again. Loader arms are working well as is the steering. I still have no movement in the 3 pt. any ideas? I admit that I don't have much experience with tractors but am mechanically inclined.- Jbuys62
- Post #7
- Forum: John Deere
-
J
1020 Hydraulics
It looks like serial # is 038124T. assuming then it is closed. I did start it, the loader arms move, steering is getting better but no movement in 3pt. I had to shut it off as there is a leak in the radiator...ugh. Filter was changed, screen cleaned, and new fluid with the pump.- Jbuys62
- Post #4
- Forum: John Deere
-
J
1020 Hydraulics
I have a 1020 that I have used for a few years. About a year ago it developed a slight noise and a vibration by my right foot. Earlier this year the hydraulics quit on me. The loader was very intermittent, the power steering as well and the 3 point did not operate at all. I was going on an...- Jbuys62
- Thread
- Replies: 10
- Forum: John Deere
-
J
1020 questions
thanks for the help! it will get me started in the right direction. I will probably get a fork set and have my son in law weld some channels on the back with the same dimensions that are on the back of my bucket. I will also look into some different tires.- Jbuys62
- Post #6
- Forum: John Deere
-
J
1020 questions
I bought a 1020 last year and this is my first tractor. It has a 146 loader and bucket on it. First question is: What front tire (design and size) should i be running? It currently has pavement type tires and on wet ground they sink like a rock even without anything in the bucket. They are...- Jbuys62
- Thread
- Replies: 6
- Forum: John Deere
-
J
1020 running issue after operating for about an hour
new to the forum but just seen this...I had a bunch of problems with my 1020 last year and found out it was the coil. I thought i ran out of gas but couldn't even put 5 gallons in it so i ended up replacing the coil with one from my 214 :) and it runs great. If you have points i think you need...- Jbuys62
- Post #9
- Forum: John Deere
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy