(800) 853-2651
SHOP NOW

Recent content by JD 435

Yesterday's Tractor Forums
  1. J

    Looking for a gas tank for a Cub Cadet 108

    please send an email to hd 99 fxr 3 at yahoo dot com. remove the spaces, replace at with @, and dot with . thanks
  2. J

    Looking for a gas tank for a Cub Cadet 108

    Don't have it. wasn't on the tractor when I bought it.
  3. J

    Looking for a gas tank for a Cub Cadet 108

    Looking for a Cub Cadet 108 gas tank in good condition. Thanks
  4. J

    Continuing saga of 435 Touch O Matic

    Final update on the 435 Touch O Matic. Using an excerpt from a 1010 service manual, that the local JD dealership copied for me, I was able to get the adjustments right. If you look under the 1010 R, RU, RUS single hydraulic section you can see the unit. It specifically says that they used a Dual...
  5. J

    Continuing saga of 435 Touch O Matic

    Not true, parts manual for 435 shows the unit in it,s entirety as it sets on the tractor now. This unit is also a perfect match to the one I stalled on 1010s. I appreciate the reply but in this instance you need to check the parts books for 435s and 1010, not a 430.
  6. J

    Continuing saga of 435 Touch O Matic

    So an update is in order. Took the unit off the tractor and took it to a gentleman that had experience with 40, 420, 430 TOMs. After paying for the rebuild, the unit still did not work correctly. One of the reasons is that even though he used the service manual from the 420, 430. The unit on...
  7. J

    Looking for Touch O Matic mechanic close to SC

    OK. Here is the update. The local person replaced the piston seals and adjusted the relief valves to 9 turns in. That was all they could find questionable. Since the 420 430 service manual does not cover the 435 specific TOM there are no clear directions on how to set the quadrant lever. So the...
  8. J

    Cub Cadet 108 Gas tank

    Thank you I will try those places.
  9. J

    Cub Cadet 108 Gas tank

    hello Looking for a gas tank for a Cub Cadet 108 Thanks in advance email should be open
  10. J

    Question for mEl

    Jon is working on a diesel engine not gas. I would think the gasket would need to be pretty stout to hold the compression. I'm thinking elongating the stud holes from an 830 diesel gasket would be the ticket.
  11. J

    Looking for Touch O Matic mechanic close to SC

    Thanks for the help. The trick did not help the situation, however I did find someone local to look at it. Just have to wait on them to find the time.
  12. J

    Looking for Touch O Matic mechanic close to SC

    Thank you for your posts. I will try that to see what happens.
  13. J

    Looking for Touch O Matic mechanic close to SC

    Thank you for your reply. So at the filler cap are two Lines that go to the back side of the Housing. There is also the line coming from the Pump. Are you saying blow air into the housing where the Pump line comes in? The unit set for a couple years with the rock shaft end separated...
  14. J

    Looking for Touch O Matic mechanic close to SC

    Like the title says I have a Touch O matic that needs someone smarter than me to figure out what is wrong with it. Filled it up via instructions in the manual. Front hubs on the ground. Without return spring attached with control and arms in raised position, you cannot move the arms...
  15. J

    tires

    To get true 14K carrying capacity you need a tire that has #3500 pounds of load rating. 235/75-16 tires do not go that high. I put 265/70-16 Firestone Transforce on my 14K gooseneck. just did 1300 mile round trip to Tunica, MS with an 8500 pound tractor. When these are 6 years old I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top