-
JJD Dave replied to the thread JD 4020 diesel.I would say without the serial number you'll never be able to determine the year.
-
JJD Dave replied to the thread Bush Hog Cutting Height?.Depends on the machine and the terrain. 3 1/2 to 4/12. Set the cylinder collars high enough so you don't scalp off spots and you don't...
-
JJD Dave replied to the thread 4010 24V SYSTEM.The factory did not offer a cab on a 4010. Any cab on a 4010 is a gypsy aftermarket contraption. If your cheap and lazy and your 24 volt...
-
JJD Dave replied to the thread Tough weed.Is it an annual or perennial? In the past I've used 2% Roundup per gallon on tough weeds with good success. If it's a perennial, now is...
-
JJD Dave replied to the thread 5410 Temperature.I'm no fan of John Deere 10 series tractors of this era. Either the bean counters were cost-saving or the engineers were on drugs. Case...
-
JJD Dave replied to the thread buzz saw blades.York Saw and Blade York, Pennsylvania
-
JJD Dave replied to the thread 1974 JD 310-D backhoe Forward-Reverse problem.Have you changed the hydraulic oil and filter? Checked oil pressure at reverser valve and/or trans port? Reverser control valve may have...
-
JJD Dave replied to the thread Question on 340.We had one back in the day. It was a decent little tractor but always seemed a little under-powered.
-
JJD Dave replied to the thread Going to need help with the French car.Always wanted one of these to replace my Gator. :) As I remember, 2-cycle. There's probably a service and parts manual out there...
-
JJD Dave replied to the thread Paint Type Choices.I'm talking paint from a reputable manufacturer. And I would NOT reccomend water-base paint.
-
JJD Dave replied to the thread Paint Type Choices.It depends on what you expect from a paint job. Do you want it to be super durable show job or do you just want a good look and it's a...
-
JJD Dave replied to the thread new Zero turn mower choices.Every manufacturer is chasing two markets: homeowners and landscaper/mow & throw. I bought my second Toro three years ago and went for...
-
JJD Dave replied to the thread JD 3020D 24v problem.It could be a generator or regulator problem. Do you have the tech manual with the electrical schmatic? Remove wires one by one from the...
-
JJD Dave replied to the thread Looking for Hyster QN-20 Parts / Service Manuals.A couple of sources for manuals: Contact Jensales. They have some Hyster manuals and do a lot of ag tractors and industrial. As I...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy