Recent content by jd435

  1. R

    John Deere AR

    I recently bought a 1951 John Deere AR. Mine has a waterpump and I would like to know if it would have a thermostat and if so, where would it be? The earlier model A's had thermosiphon. Thanks.
  2. A

    farmall m brentzappe

    Brent, I have a hood, small dent, grille, missing the center and the gas tank support. Let me know privately. Thanks.
  3. J

    620 carburetor problem

    2ND POSSIBILITIES IS CHECK THE INTAKE MANIFOLD. i HAVE SEEN THEM GO TO PIECES INTERNALLY AND MIX AIR FROM THE HOT - COLD SIDE OF WARMER ,AND MAKE THEM RUN LIKE THAT . LOOK IN THE CARB SIDE AND THEY DECAY AT THE BEND .TOOK ME MONTHS AND A LOT OF HEAD SCRATCHING TO FIND IT .GOOD LUCK JD435
  4. J

    Omaha to Denver site seeing

    Is there any neat places to stop between Omaha and denver[ 80-76] . Old tractor or car musiums or anything else of interest.Have a few hours to spare thanks 435
  5. J

    OT: Roofing suggestions?

    decras run about 2.5 times higher than 15 year asphalt. If you are under the age of 60 put on Decras?? Buy the time you put asphalt on the 2nd time the decras will look cheap!!!!LABOR AND MATERIALS ARE NOT GETTING CHEAPER!!!!!!
  6. J

    Furnace burner blowing back ?????

    Check or replace the two regulaters outside of the house!!! If there old they could have rust and not giving the right gas preasure
  7. J

    730 LP VALVES OR REPAIR KITS

    Find another LP supplier!!! i called deere yesterday looking for a converter rebuild kit for a 630 .Century model H $$$$ 565 $$$. called local LP supplier ,he was thinking $60 if he read his price sheet right?There propane parts first then deere parts .. enjoy
  8. J

    630 axle sprockets.

    I have a JD630 lp that i have that has cast sprockets on the axles[ Both sides].they are between the axle housing and the tire on the axle.They are a double sprocket with a 9 tooth and a 12 tooth sprocket. part # is P-1884-B and P-1885-b with aJD symbol on them also. they have a JD symbol on...
  9. J

    Installing overdrive in jd 36 b

    Also i am looking for a behlen for a unstyled B 712-210-2247
  10. J

    Installing overdrive in jd 36 b

    like PBB said.First take top cover off of tranny.Remove shift forks.pull top shaft and gears. lay them out on floor as they come out of tranny. do the same fore the bottom shaft. you will not use the original shafts. you will put back together with longer behlen shafts. when tranny is all back...
  11. J

    U.S. B tranny gears

    I know behlen has made an aftermarket 4th & 5th gears for an unstyled B . they are hard to find!!! Has anyone ever changed the crankcase, transmission with a 41or 42 b transmission just to get the faster road speed for tractor rides????I know it would take a lot of time but can it be done?? thanks
  12. J

    630 John Deere

    what side of the state of iowa??? thanks
  13. J

    530 water pump

    yes,if you can press it apart without breaking the impeller and housing.rather than buying a new impeller, have a machinist cut down the impeller face[were the seal rides] good luck
  14. J

    need gear for tach drive on a 430 john deere

    I,HAVE ONE 712-210-2247
  15. J

    Waste oil heat?

    Put in the tubing! After working in a shop with floor heat you will never go back!The two biggest expences of floor heat in the insulation under the floor[saves enengy] and the labor to install everything[tubing]. to get my system going i found a used boiler coming out of an older house[$200]and...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top