(800) 853-2651
SHOP NOW

Recent content by JDHDon

Yesterday's Tractor Forums
  1. J

    DLTX 46 Adjustments

    Thanks Randy. I'll send you the carb. I have a local tractor show on Sep 28-30..any chance you can have it back to me by then?
  2. J

    DLTX 46 Adjustments

    Thanks guys. I'll see if I can run through this in the next couple of days. I may also need to have the ports drilled out. Can you email me separately your info(price/timing/shipping address) in case I want to send you my carb? Thanks.
  3. J

    DLTX 46 Adjustments

    What is the best procedure for adjusting my DLTX 46 on my H?
  4. J

    JD H Carburetor Adjustment

    Randy - would consider sending my carb to you...need your contact info.
  5. J

    JD H Carburetor Adjustment

    I was able to remove most of the brass screws. The only ones I couldn't get to were the 2 behind the flange to intake manifold. With that, I did as suggested and it died when I closed the Load valve....so I'll be happy to send the carb to you to take a look at it, clean it, etc. I think most...
  6. J

    JD H Carburetor Adjustment

    Thanks. I have not tried to remove the brass plugs. I'll give it a try and see what happens.
  7. J

    JD H Carburetor Adjustment

    I'm struggling to get my hand crank H running well after sitting all winter (yes, winter is long gone). My usual starting procedure is to barely open the throttle lever and go to full choke. After a couple of pulls on the flywheel, engine starts to run and I let it run for a few seconds on full...
  8. J

    8N won't fire

    I just went through this on my front mount 8N. I had 2 problems 1) the inside center contact of the distributor cap was eroded to the point the rotor could not make contact and 2) the coil tab (not the springy thing) was not making contact with the cap. I put a used distributor cap on and when...
  9. J

    NAPA Part number

    How do you know which circuit (A or B) you have/need for your particular tractor. I've never seen this designation before.
  10. J

    8N New Dist Cap - Shot

    Not now. I'm assuming this is why I have no spark. I'm hoping a new cap does the trick.
  11. J

    8N New Dist Cap - Shot

    I put in a new front mount dist cap 3 months ago. The tractor (early 8N, 6V, front mount dist) was running until a few days ago when I decided it was time for new points, condenser, etc. It hasn't run since and I have no spark. Last night I noticed that the center contact on the almost new...
  12. J

    Hard Starting 8N

    Thanks for the clarification...never too old to learn something new. She started right up tonight so I"m going to leave good enough alone for a few days. Thanks.
  13. J

    Hard Starting 8N

    Not sure what you mean by dry and wet test...only way I know to do a compression test is to remove spark plug, screw in gauge, turn it over with no fuel, no ignition. If it starts up this evening, i'll leave good enough alone.
  14. J

    Cub Cadet 1450 running problem

    Thanks everybody. Sounds like the condenser is a good starting place. Where's it located and how tough is it to replace?
  15. J

    Cub Cadet 1450 running problem

    Any suggestions short of doing a valve job?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top