Recent content by jdkremer

  1. J

    JD 1020 Charging problems

    SUCCESS! Thanks all for the help. The new voltage regulator that I bought was defective. Once I tried another one, it worked just fine. In the process, I sure did learn a lot about the wiring of this tractor.
  2. J

    JD 1020 Charging problems

    Thanks for your continued assistance. I have confirmed that I do have power going into the VR (at least into the male connector) from the ignition switch but no power going out the VR through the wire that connects to the field terminal on the alternator. I will keep studying the wire diagram...
  3. J

    JD 1020 Charging problems

    Well, I checked the field terminal wire (green wire) all the way back to the male connector on the wiring harness (that plugs into the VR) and I have continuity. I even moved the wires around some in case there was a bad spot that would occasionally appear to be okay...same thing, continuity...
  4. J

    jd 1020 control arm leak

    Thanks again. So you would just try a new shaft first? If I still get a leak, change the bushings or seals? There might be a little wear on the shaft as it slopped around a little (The way it was when I bought it this summer). What about the seals/o-rings. How does one get those out...
  5. J

    jd 1020 control arm leak

    Tx Jim...Thanks for your time. One additional question... How to I go about removing the bushings/seals? Do I just get a long punch and drive it out from the other side, or do I need to go inside the back end in some manner. What special tools do I need if this is not the case? Do not...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top