-
J
Farmall H bore size questions
Clint, Your "H" block can be bored for a 350 type sleeve but I do not how much meat will be left in the parent bore of the block. You might consider finding someone that can sonic test the blocks cylinder walls befor boring that much. I think an H block has a parent bore of 3.562 where as the...- Jeff Asbury
- Post #1
- Forum: Tractor Pulling
-
J
9 bolt wheels
Is the pilot diameter / hole in the center of 9 bolt wheels all the same for various makes of wheels? And what is that diameter? Thanks Jeff- Jeff Asbury
- Thread
- Replies: 4
- Forum: Tractor Pulling
-
J
camshaft
Looking for a cam for a Ford Super Major diesel. I have been told the gas engine uses the same cam. Single bolt design, casting # DKN6250E- Jeff Asbury
- Thread
- Replies: 2
- Forum: Tractor Pulling
-
J
camshaft
Looking for a cam for a Ford Super Major diesel. I have been told the gas engine uses the same cam. Single bolt design, casting # DKN6250E- Jeff Asbury
- Thread
- Replies: 1
- Forum: Ford
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy