Recent content by JeffEck

  1. J

    Case Taskforce 700 Trencher/Backhoe

    What is your question bud? I don't know what model you have, but I can take photos of mine if you want me to show you different parts to help with your issues...
  2. J

    Case Taskforce 700 Trencher/Backhoe

    I have both a TF300 and TF700 now and I believe the tracks are different. I'll go take some photos and looks closer after the sun comes up and post back here.
  3. J

    Case Taskforce 700 Trencher/Backhoe

    I sent you an email on the manual.
  4. J

    Case Taskforce 700 Trencher/Backhoe

    Thank you for the heads up. Any suggestion on the hydraulic oil? The conveyor's speed adjustment valve leaks quite a bit and I didn't notice until I had left plenty of oil on the ground.
  5. J

    Case Taskforce 700 Trencher/Backhoe

    I found the grease cylinders were intended to move the differential back to tighten the tracks. I used a porta power and have successfully tightened the tracks. Once I understood what it was supposed to do, I just worked around it... At some point when I get to overhauling the motor I will...
  6. J

    Case Taskforce 700 Trencher/Backhoe

    I recently purchased this machine to use on our house project. I have searched and searched for an operator's manual and ordered one on eBay that was in Brittian. I have been waiting for the manual for some time now.... On Friday I was working with the backhoe and went to move the machine when I...
  7. J

    Case Taskforce 700 Trencher/Backhoe Wisconsin VH4D

    Compression is tested hot is 65-67 psi on 3 cylinders and 70-72psi on the other. Gauge only has the 10s marked and no graduation in between, but that is best I could read the gauge. What is good compression for this motor? I'll check the compression when the motor cools down again.
  8. J

    Case Taskforce 700 Trencher/Backhoe Wisconsin VH4D

    Some photos of the machine.
  9. J

    Case Taskforce 700 Trencher/Backhoe Wisconsin VH4D

    Timing seems to be correct. I have ordered and received a gasket set so after I run a compression test I'll pull some heads to look for damage. I am hoping to find bad rings that can be replaced and no real damage. I have a project I really need to get this working for. We purchased a house...
  10. J

    Case Taskforce 700 Trencher/Backhoe Wisconsin VH4D

    I am not allowed to post any photos. Just one photo causes the forum to reject my post. What am I doing wrong?
  11. J

    Case Taskforce 700 Trencher/Backhoe Wisconsin VH4D

    I have a high quantity of blow-by coming out the oil fill tube but no smoke out the exhaust. When I run the trencher I seem to be very low on power. I am not certain the throttle govnr linkage is working properly. Throttle response isn't instant and when the motor is under load the throttle does...
  12. J

    Case Taskforce 700 Trencher/Backhoe Wisconsin VH4D

    I have been struggling with the auto sensor on the forum telling me that I am using words that are not allowed. I have cut 90% of the message in hopes that the forum will allow me to post.... This post was edited by JeffEck on 11/05/2021 at 11:58 am.
  13. J

    New to me 9N with issues.

    Does anyone have any advice? Would the governor do this? Is this totally the cheap carb and should I purchase another of higher value? I really would appreciate any advice you guys could give. I'm at a loss on this.
  14. J

    New to me 9N with issues.

    Fuel Flow Seems adequate. Flow didn't seem to slow, so I figure the carb bowl wasn't emptying out.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top