-
J
rebuilt engine on 2000
engine starts right off, good oil pressure, just lots of smoke and will not rev up. i sure it's either injectors or pump, didn't pull pump, just major ovrhaul of engine, rings inserts, mains head resurfaced with new valves, springs and the whole nine yards, had the crank miked, it is OK...- jerrell-HT
- Post #1
- Forum: Yanmar
-
J
valve timeing
have a 2000 ym, and rebuilt the engine, do you use the first notch on the crankshaft to time valves or the second notch,?- jerrell-HT
- Thread
- Replies: 0
- Forum: Yanmar
-
J
rebuilt engine on 2000
Air filter good, will check compression but know it's strong, one more question in timeing , the valves are set for 17mm , both exhaust and intake, but my manual is smeared so bad can/t figure the notches on the crank shaft, i can feel two marks or notches, do you set it on the first mark as it...- jerrell-HT
- Post #1
- Forum: Yanmar
-
J
rebuilt engine on 2000
Hello everyone, new on here, very frustrated, have a yanmar 2000, great tractor for a few years, then had to rebuild engine, new rings, head, gaskets, valves, the whole nine yards, my problem is , the tractor will start right off, but smokes like crazy, very black smoke, lots and lots of smoke...- jerrell-HT
- Thread
- Replies: 14
- Forum: Yanmar
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy