(800) 853-2651
SHOP NOW

Recent content by jim from az

Yesterday's Tractor Forums
  1. J

    clutch on 630

    o k thanks for the info,, Yt doesn't have a manual for 630.... sorry to have bothered you bothered you
  2. J

    clutch on 630

    I have a 630 case diesel early 60's no serial, wide front. I got a manual but was generic with other models and not clear.. the clutch engages all the way out.. I think it is a hydraulic clutch, can it be adjusted?i couldn.t see an adjustment. thre is like a small 3/4 inch piston like thing...
  3. S

    mercury night light

    this light only stays light for 5 to 10 min then turns off have put new eye on it with no change What is next thing to try
  4. J

    #1 on waukesha distributor

    thanks chuck that makes sense.. i have it in moubtains about 200 miles away i wil go there in 10 days or so and i will try that.. where is korves tractor??are they online? thanks jim
  5. J

    #1 on waukesha distributor

    thanks chuck..never thought of that.. how would i check that?? that would make it run good under a load??thanks jim
  6. J

    #1 on waukesha distributor

    hi thanks it runs bad unless u have it under a load and then it runs good.sounds great.i"ve tried adjusting the carb and it needs a lot of gas.. someone put a electric fuel pump on it and a valve at carb.. which needs to be set at the highest.. it runs clean and doesn"t blow smoke it has 110...
  7. J

    #1 on waukesha distributor

    i got a michigan loader with a 6 cyclinder waukesha 190 motor in it.. tuned it up and it runs like the spark plug wires are wrong checked firing order and it"s right but not sure which is #1 on dist if #1. cyclinder is at top , will rotor point to #1?, didn"t have new dist cap, but it looks...
  8. J

    H tires

    where did u get the titans from tiretown? thanks jim
  9. J

    H tires

    where did u get the titans from tiretown? thanks jim
  10. J

    farmall c carb

    hi gene i set this adjustment with drill bits for the gauge on the brass part that is soldered to float next to needle.., after about 6 times,, i got it to where it will run with choke out but it still leaks from carb any adjustment more and it leaks and floods out and any less and no fuel...
  11. J

    farmall c carb

    thanks gene i will try it next week i'm gone for a few days thanks again jim
  12. J

    farmall c carb

    the kit i got from here didn't have any instructions,, do u know the setting.. i've tried changing it 6 times it's either too much or no gas to bowl.. thanks jim
  13. J

    farmall c carb

    i have a c with a zenith carb,, it was leaking out of carb so i cleaned and put a new needle and seat in it in spring.. it ran well then,, i started it last week and it was leaking so i adjusted the float down a little and now i can"t get gas to carb if i adjust the float higher it gets too...
  14. J

    farmall h governor

    hi the book says to adjust the rod with the throttle wide open when it's wide open , there is no play.. i don't think that throttle shaft to carb is hanging up it was clean and i could turn the butterfly in carb easy and the shaft turned easy i don't understand what is going on the exhaust...
  15. J

    Tractor tires info

    can u tell me the site do u think they might still have some thanks
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top