(800) 853-2651
SHOP NOW

Recent content by Jim Mitteer

Yesterday's Tractor Forums
  1. E

    1370

    I have a 1370 I just brought in and got running. Engine seems good, powershift, tranny and lift all work fine. Problem is when you push the clutch in you have to set your toe back under it and ease it up to take off. Tractor sat 4 years, man assures me it did not do that before. What is the problem?
  2. T

    460 diesel battery configuration

    I know the specs call for 2-6Volts in series, would I get more power out of 2-12's in parralel? Gonna buy new batts for it, just looking at options before I spend that money. Also does NAPA have a good hytrans oil? I don't have an CIH dealer within 150 miles of me
  3. 6

    60 main bearing

    hey guys needing to know if there is a place to get aftermarket main bearing for a John Deere 60 thanks for the help
  4. S

    Overhauling Oliver 60 Row Crop

    Needing to overhaul my oliver 60 row crop. Where can I find all the replacement parts and gaskets sets.
  5. S

    Possible PTO Issue

    Hi Folks, Dad has a 1962 Fordson Dexta (09B716466), gasoline engine, with a live PTO. The other day dad was bush-mowing (I believe 6-7 foot diameter), when the blade stalled and literally stopped spinning. After quickly depressing the clutch and disengaging the PTO he removed the obtruction...
  6. J

    Oliver 550 serial number

    I have a oliver 550 with 214 341 019 as the serial number but it does not match any of the records for one. Does anyone know anything about this or am I just reading it wrong?
  7. D

    JD 316 w/Onan electrical question

    My 316 with the Onan engine has just quit with out warning for the second time. Mowing about an hour in 85 degree weather it quits instantly. No panel lights, good fuses, good battery. The next day it starts and runs fine and then quit again. I have a couple of questions for the experts. 1. The...
  8. J

    1952 Case DC 4 Tractor Hand Clutch Engage Problem

    Someone has adjusted the clutch too tight. You need to take the cover off the side of the clutch housing and back off the collar a couple of notches. Your DC owners manual shows the procedure.
  9. J

    oil pressure problem on 1935 A

    Does it lose pressure while running or does it just seem not to prime up when you start it? Is this a "redhead" oil indicator A? JIM
  10. J

    float for D Case

    McDonald Carb has your float. Model 62 Float
  11. J

    Case CC carb problems

    I am pretty sure McDonald Carb and Ignition has your float. McDonald Carb
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top