(800) 853-2651
SHOP NOW

Recent content by jim warehime

Yesterday's Tractor Forums
  1. J

    NAA Steering box

    Rebuilt the Steering box today using all parts from this site. Mine is the original box so I used the correct early style sector gears as per description in parts listing. Steers sharp to the right but shallow Steering to the left. I notices that the new gears have less teeth then original...
  2. J

    NAA Engine Overhaul Kit

    My tractor serial is 28053, are these dry sleeve engines? What are the best overhaul kits to use in these engines? Thanks Jim.
  3. J

    NAA Major Service/Maintenance

    Thanks for the input, my intention is to overhaul engine next winter once I'm done using it for the summer. I know the rear hubs are a little loose which I plan on addressing along with new brakes and seals/bearings. The right side axle trumpet also needs to be replaced as the 3pt arm stud is...
  4. J

    NAA Major Service/Maintenance

    In the process of getting my grandparents old NAA up and going again, tractor was used very hard over the years and got very little tlc. Plan on completely rewiring and updating electrical system to 12 volt neg ground and electronic ignition (everything has been already purchased from...
  5. J

    Farmall M Steering Shaft Support

    Check pilot knob restorations he may have replacement or can install new bushings in your shaft supports
  6. J

    Farmall M Steering Shaft Support

    Check pilot knob restorations he may have replacement or can install new bushings in your shaft supports
  7. J

    Supplier of Gaskets for WD9

    Gerald Carr at Carr's Repair international falls MN.
  8. J

    Ford NAA Help

    Ok, thanks for the info. Guess I need to locate a parts naa...
  9. J

    Ford NAA Help

    Will the right side (setting on seat) axle housing from a 800 fit a NAA? Thanks jim
  10. J

    Ford NAA Help

    Ok thank you, hopefully my parts book will be here in a few days.
  11. J

    Ford NAA Help

    Ok this makes sense now, those seraded plates are missing on my tractor
  12. J

    Ford NAA Help

    Thanks for the response, how do the parking brakes actually engage? I looked at my tractor it has the little lever looking things on the linkage but I can't figure out how it works, leads me to believe something is missing.
  13. J

    Ford NAA Help

    I figured that casting would need replaced, are they interchangeable with other models or sticky naa/jubilee? How do the parking brakes actually work on these tractors. Trying to figure out if I'm missing any peices.
  14. J

    Ford NAA Help

    I already have the IT manual and am waiting on the parts catalog. I will check the hubs to see if loose on shaft, if so can they be tightened or will they most likely need replaced? As for parking brake the tractor never had them in my 37 years of being around it on the farm, not sure if...
  15. J

    Ford NAA Help

    I've always been a farmal guy, I have a golden jubilee that was my grandfathers that I recieved after his death.tge tractor was running but has sat for a few years, when I last used it known problems that I am ready to fix are, worn rear axle bearings. Right side lower 3pt stud has been...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top