(800) 853-2651
SHOP NOW

Recent content by jim950

Yesterday's Tractor Forums
  1. C

    1949 8n ford startup after sitting for 30 plus years

    I have a 1949 8n ford that has sat for over 30 plus years. I tore it down and fixed or replaced all parts that were need. I now have it back together and have tried to start it. The compression is #1 at 85 lbs # 2 at 75 lbs #3 at 80 lbs and #4 at 70 lbs. It will not pull the gas mixture from...
  2. J

    Tractor Pictures From Today

    Kruser, is that your 550 next to the UDLX? If the rest of the tractor looks as good as the nose, you did great!
  3. J

    Some Olivers from Florida Flywheeler show

    Jim, if you still have that bail money for glennster, go ahead and spend it. I'm sure he will understand!
  4. J

    router -saw foot control

    Glennster, if it was me I'd get a 4"x4" ele. box and attach it to your router table. I'd get a on/off switch and a recepticle and a plug in cord. Wire the recepticle to be controled by the switch which is powered by the cord plugged into the wall. Plug the router into the added recepticle with...
  5. J

    Half Century of Progress Show..2017

    That will be really neat to see. In 2015 they hooked 2 big Massey 4 wheel drive tractors together to pull 2 10 bottom IH plows. You suppose Roy could do that alone?
  6. J

    Day off in Knoxville

    Knoxville, WHERE??? I'm only about 5 miles from Knoxville IL, 125 miles from Knoxville, IA and probably close to 400 to Knoxville, TN.
  7. J

    Central Illinois YT Get Together

    Kruser, better count me in for 1. And you better re-think sending glennster off with the women folk...we have all seen him dressed to the nines with that snazzy clip on tie...a real lady killer! Just sayn'.
  8. J

    ID weights

    I forgot to add, highly sought after, hard to find, and worth some $$$.
  9. J

    ID weights

    Tim, your weights will fit the Super series and the three digit series. The fleetlines did not have the flat mounting pad on the front to attach the starter weight.
  10. J

    OK Gun You Guys

    kruser, look on Simpson's site. They are Luger guru's. There are so many variations it would be hard to give a price without more information.
  11. J

    cheetah air tank

    I would use an air tank from a semi. They are fairly small, no propane to deal with, and are rated for the pressure.
  12. J

    Air hose fittings.

    In the Milton line I think the high flow fittings are called a model "P".
  13. J

    Ford 3000 + Silverado 1500?

    Make sure you have good trailer brakes and you should be fine. Just take it easy.
  14. J

    Gun Safe Location

    Kruser, the best location would be at MY house!
  15. J

    Farmall M: Radiator - Crud, Gunk / Carburetor Leak

    blue33, Can't help with your carb, and the oil leak might just be a sign of age on a seal or gasket. Your coolant sounds like someone mixed some red (GM Dexcool) antifreeze with the old green. I'd get it out now and refill with the "global" (yellow) antifreeze that will mix with anything. Any...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top