(800) 853-2651
SHOP NOW

Recent content by jimmi

Yesterday's Tractor Forums
  1. J

    Gauages on 245

    Is what the back of yours looks like? The bottom stud is marked as the ground connection. The other two are not shown in the picture but there should be either an "S" or "I" next to one of the two. "S" goes to sender and "I" goes to the oil pressure switch with the other side of it...
  2. J

    NH 311 Baler, strings are tight one bale, very loose the nex

    I don't have a NH 311 baler but on mine it has a twine tension and individual springs for each twine where the twine exits the twine box. If tension is not maintained on the twine, it will pull extra twine out and if the slack is not removed before tying you could have loose bales.
  3. J

    TO20 Gear shifter

    I think you are looking for p/n 825865m91. You could try here.
  4. J

    Fix that Ferguson (parts place)

    AKA "fix that ford". Google the address list on the site, it points to a residential house if I recall correctly. Ordered some parts for the neighbors Ford. Parts finally arrived but took a long time. I had sent one email about when to expect the parts and it was answered in a timely...
  5. J

    Perkins AD4.203 Exhaust Manifold Torque

    Book says Exhaust manifold 21-24 ft.-lbs
  6. J

    MF 12 baler plunger bearing change: how to do it please!

    The service manual does not have a specific section about that bearing. Between looking at mine, the parts manual and the service manual I think you would need to do the following. 1. Main drive gear: remove plug and drain oil. 2. Turn plunger crank arm, on end of main drive gear, to its...
  7. J

    MF 255 external hydraulic leaks.

    Some of the lines may have too hard of a bend for a soft line. I did find listings for some of the hard lines, but I don't know which you need. Do you know if the PTO is "Live" (3 positions on pto lever) or "Independent" (2 positions on pto lever)? Hard pipe lines are different for each.
  8. J

    MF 255 external hydraulic leaks.

    The Agco part catalog link may not be the correct one for your tractor. There are a number of pages depending on single or dual spool valve and tractor serial number range. You will need to find the correct page for your tractor. If the filter o-ring for your tractor is 359110X1 (4-3/4: ID x...
  9. J

    MF 255 external hydraulic leaks.

    Parts diagrams are available from Acgo.com Link is page you are interested in. http://www.agcopartsbooks.com/PartsBooksN/Viewer/book.aspx?book=agco/651351&page=318 I also have a 255 but with the Perkins AD4-205. I have had my lines disconnected a couple of times and never had a problem...
  10. J

    sharpen woods RM-59

    I pick the mower up with the 3pt, shut the motor off and use an impact wrench to remove them. With the impact you do not need to hold the pulley with the tool, just grab the blade to keep if from spinning. Then I sharpen on a bench grinder and balance them. Then put them back on with the...
  11. J

    Led clearance lights on trailer fenders

    Are these facing forward or to the side? If forward, I would move them to the side of the trailer toward the front, facing the side. If the lens is clear, find one than defuses the light. Looking directly at the center of a non-defused LED will be very bright and blinding compared to looking...
  12. J

    Knotter issue Anyone?

    Also check the spring and tension at the twine box. If it pulls to easy or the spring is broken it can cause the same problem of the twine not being pulled into the bill hook.
  13. J

    Knotter issue Anyone?

    The needles deliver the twine to the twine disc, the twine finger can be way out and the twine disc will still pick up the twine. The function of the twine finger it to put the twine to the bill hook so it can grab it. So it sounds like something is loose on the twine finger allowing to move...
  14. J

    Do foxes kill fawns?

    A couple weeks ago, after dark when I went to feed, I saw a coyote in the back yard. Turned on the flood lights and there were three does standing about 35 yards away watching the coyote. The coyote ran to the front of the house and the three does followed. When the coyote came to the back...
  15. J

    22 rifle

    Winchester 52A. Dad purchased it used in about 1940. I usually tag 2 or 3 woodchucks at 100 yards each year.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top