-
J
1963 Ford 2000
So until I go through all other diagnosis options, I should probably leave that there? Any advice on the hole in the housing? That has me very concerned. :( -
J
1963 Ford 2000
So I dug into it a little bit and discovered the silver circular piece in the picture. I assume this is the valve? How do I pull it out? And MORE importantly, there is a hole through the housing, directly under the hydraulic tubes. The edges are rough, so am I correct in assuming that... -
J
1963 Ford 2000
Can anyone tell me IF a 63 Ford 2000 is SUPPOSED to have a pressure relief valve for the 3 pt lift? And if so, WHERE it is supposed to be? It was my understanding that they screw into the bottom of the tractor. But I don't see one under there? Thanks! -
J
1963 Ford 2000 (Starter Solenoid question)
My Ford 2000 has been converted to a 12v system and I believe the starter solenoid is bad. I have seen several threads on here discussing these solenoids, but I can't seem to find out if I need a solenoid that is grounded through the base (or not). The current wiring setup eliminated the... -
J
1963 Ford 2000
I do agree about the diagnostics, but I'm learning about engines with this project. Everything I replaced appeared original, so I figured it wouldn't hurt! I'm not home right now to test all the continuity checks you mentioned. I do know that there is a small white wire that runs from the... -
J
1963 Ford 2000
Some of you may remember helping me out some time ago with identifying and trying to get my tractor running (again). I have recently begun working on it again (still not running). I have put a new starter, electronic ignition, battery, plugs/wires, rebuilt the carburetor, ignition... I have... -
J
1963 Ford 2000 wiring questions
I'm not quite following you. How do I know which big post the battery positive cable goes to and therefore, which big post goes to the starter? If I hook up both of those big wires, and nothing else, what will tell the starter to "go"? Thanks! -
J
1963 Ford 2000 wiring questions
I have several things going on with this 2000 that I bought this year, but I want to address some wiring questions to begin with (for now!). I will try to keep this as short as possible. The tractor was running just fine (not great, but fine), then it sat for a few weeks while I couldn't...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy