-
T
9600 PTO shaft stuck
I have a 9600 ford that I can"t get the 1000 RPM PTO shaft out of to put in the 540. Took the retaining ring out and it will move in and out about 1/8 inch. I tried to yank it out with a slide hammer but did not have any luck. Anyone got any ides about what it might be catching on. Thanks for...- Travis at mo
- Post #1
- Forum: Ford
-
J
830 engine
Is the rest of the 830 donor any good? I am looking for low tin 830s, if you have any parts to sell let me know.- jimmybobtom
- Post #1
- Forum: Case & David Brown
-
J
For justincase
How in the world do you get that sc to weigh 4000 pounds?- jimmybobtom
- Post #1
- Forum: Case & David Brown
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy