Recent content by Joebuyscorn

  1. D

    SMD injector pump rebuild

    Where is best place to have injector pump rebuilt?
  2. J

    Farmall A hand lift cultivator

    Email me and I can send you some pics.
  3. J

    Farmall A hand lift cultivator

    I have one in Iowa, let me know if you would like to see pics.
  4. J

    Farmall M weak starter?

    Have a 49 m that sat for 15 years, got running 3 years ago, then sat again since then. starter is not engaging flywheel. When i pull the starter off it spins good and looks like it would work, but when i put it on tractor it just hums. I am putting the voltage right to the starter the same way...
  5. J

    A vs super A

    Have a 39 A with a one row cultivator that I went through this winter down to replacing a few piston rings.(Thanks to the forum for help on multiple occasions!) This had sat for 30 years but now is running great. These farmalls are amazing! Anyway, had a friend offer me a 54 super A for...
  6. J

    How to clean the head

    Pulled the head off my A to get a look inside and start the cleaning process. What's the best way to clean the carbon gunk off? Soaking in kerosene an OK way to go? What about the gunk on the Pistons?
  7. J

    Farmall A, I'm stumped, won't fire

    Boy I can barely get 1/8 inch spark with a screwdriver and it's yellowish. What else should I be checking?
  8. J

    Farmall A, I'm stumped, won't fire

    By rotor timed do you just mean the gears lined up properly? Is there anything to what some guys say about getting "HOTTER" spark plugs? Would replacing the coil do anything?
  9. J

    Farmall A, I'm stumped, won't fire

    Sounds like I do have too weak of a spark (altho that might not be my only problem). How can I get a better spark out of the magneto? Anything I should clean/replace?
  10. J

    Farmall A, I'm stumped, won't fire

    First off thanks to everyone who has replied to my previous posts. Can't get this 39 farmall to fire. Below is what I have done and checked. Whats my next step? Could I have messed up the timing the first time I took the magneto apart? Would I even be getting spark if so? Would that...
  11. J

    Farmall A sat for 30 years, no pop

    What should the compression be?
  12. J

    Farmall A sat for 30 years, no pop

    Got spark, fuel to carb, cranking over really good (after replacing battery cables with 00 Guage thanks to advice from the forum!) Not popping when trying to start. Where can I find what the carb settings should be? Should I take apart the breather deal? Could air be my issue? What else should I...
  13. J

    Farmall A turning over very slowly

    Thanks for the quick responses everyone! I'll track down some 0 Guage cable and go right to the starter bolt tonight and try that. Probably need to drop the oil at some point too. Any suggestions for which oil to replace with? Does it have to be non detergent?
  14. J

    Farmall A turning over very slowly

    Finally had some time to work on my new farmall tonight. It had sat for over 30 years but was driven to its parking spot. rebuilt carb, new points and good spark. New battery. Hooked up jumper cables direct to a starter bolt and put other end right to the copper on the starter. Very slowly it...
  15. J

    Farmall IHC Cultivator parts?

    You talked me into keeping the complete cultivator, but planning to sell the extra parts to finance the rebuild of the A. Thanks again for your replys!
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top