Recent content by JoeDK

  1. J

    JD 1020 Charging problems

    No power at the connector. Will have to see if there is a bad wire. I just sent you an email. Thanks for your help! This post was edited by JoeDK on 06/02/2022 at 07:10 pm.
  2. J

    JD 1020 Charging problems

    Thanks for the idea. I was also thinking that was my next step. I do not have a wiring diagram but can probably find one on the internet some place. Yes, I meant to say charging light. I will need to be more careful in my use of terms in the future. Thanks again for your help. Much...
  3. J

    JD 1020 Charging problems

    I have a 1966 1020 Gaser. 12 volt system. I am experiencing charging problems. Generator light is on. At first I thought it was the alternator as I was only getting a voltage reading for what the battery itself was putting out with the tractor running, about 12.3 volts (after trickle...
  4. J

    JD 1020 Hydraulic Oil Line Question

    In looking at the parts schematic, I believe that one does have a check valve. Thanks for the words of wisdom!
  5. J

    JD 1020 Hydraulic Oil Line Question

    Thanks for confirming. My guess is that these lines have never been removed...and the tractor was built in 1966. Sprayed some PB on them last night. I will do that a few more times to see if that will loosen the hold a little. Then, patience and perseverance, I suppose.
  6. J

    JD 1020 Hydraulic Oil Line Question

    Finally getting back to this project. I have radiator removed and all other parts that will get in the way removed. Next question....I am not sure how the oil line is secured to the tractor housing on the opposite end of the pump. Appears to be a cover plate that holds two lines into the...
  7. J

    JD 1020 Hydraulic Oil Line Question

    There are three steel oil lines that follow roughly the same route and are all bundled together in the hangers that you mentioned. The one that has a connection about half way down is not the one that I need to work on. It figures! Thus, no way to "shorten" it. Thanks for the information. I...
  8. J

    JD 1020 Hydraulic Oil Line Question

    Thanks. Do you have experience removing the lines? Not much room to play and the oil line does not have much, if any, flex in them. Not sure if I can get them removed without taking some other things out of the way first. Will I need to remove the radiator first? Or, some of the other lines...
  9. J

    JD 1020 Hydraulic Oil Line Question

    Yeah, I have studied these pretty closely already. I have a small crack in one of the joints in the oil line. Going to try to Braze it, but need to remove it first. I have all fluid drained, and all other bolts and fittings removed with the exception of the pump connection. I do not current...
  10. J

    JD 1020 Hydraulic Oil Line Question

    Needing to replace a hydraulic line that is leaking. Need to remove flare nut from pump. Helpful hints...Use a big flare wrench to remove??? Box end??? Appears as though nut is made out of a softer metal and I do not want to damage it. How tight are these typically? Can't apply heat (or do...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top