-
J
Mustang hydraulic hose connections
To make a long story short-its been 5 years and so, so many problems, mostly caused by my failure to pay attention and now I"m finished and ready to roll. Except for one thing. I"m not sure which hydraulic hose connects to the different inputs of the hydraulic unit. Each one comes from a...- John Fila
- Thread
- Replies: 0
- Forum: Massey-Harris & Massey Ferguson
-
J
Ford 5610 forward/ reverse shifting problemt
Strange thing is the problem is helped by the reverse of what you describe. You suggest coming to a complete stop before shifting. I cant come to a complete stop then shift. But can shift if I'm still moving. Thanks for the shifting procedure but I sure hope I don't have to follow it. I do a... -
J
Ford 5610 forward/ reverse shifting problemt
Although I agree with Rick, I can't say that it doesn't grind at all. In order to shift, if I let the clutch out just a bit and it slips into gear, there is a bit of a grind and the tractor lurches. This occurs early in the cycle well before there is any evidence the tractor wants to move. In... -
J
Ford 5610 forward/ reverse shifting problemt
Thanks for joining the discussion Rick. I didn't know you were a participant on this forum. Just one comment/correction to your post; Placing the 1-4 in neutral sometimes, but not always, allows me to Hi-Lo-Reverse shift. I do want to take a sentence the thank Rick for his helpful and very... -
J
Ford 5610 forward/ reverse shifting problemt
I'm not sure exactly what parts were replaced but I think they probably did a thorough clutch repair and included all the parts and properly adjusted it all. The thing is none of that had the slightest affect on the problem. -
J
Ford 5610 forward/ reverse shifting problemt
Its not what I would call a conventional floor mount with the levers going straight down into the transmission. They mount on the right side of the column housing the steering shaft -
J
Ford 5610 forward/ reverse shifting problemt
No trouble shifting 1-2-3-4 but the Hi-Lo-Reverse symptoms are about the same as what you describe. It would sure be a surprise if it was a linkage problem. But at least a pleasant surprise. -
J
Ford 5610 forward/ reverse shifting problemt
My local dealer just returned my tractor with a new $3000+ clutch put in, at his suggestion, to fix exactly the problem I am describing here. Tractor is a Ford 5610 4WD synchromesh, four speed(8 speed with hi/lo), with a separate lever to shift from between forward Hi,forward LO and reverse...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy