(800) 853-2651
SHOP NOW

Recent content by john greenawalt

Yesterday's Tractor Forums
  1. J

    WD Battery Question

    So my dad and I recently inherited a couple tractors and one is a WD. We were working on it a little bit tonight and we are getting to the point that we are getting ready to try and turn it over. It is a 12v system and we had a spare 8v battery laying around in the garage. Can this be used or...
  2. F

    Sealing rear main bearing cap on perkins diesel

    I am putting the crank back in my perkins and one manual mentions using hylomar under the rear bearing cap flat surfaces. The other manual is silent on putting sealant down. Seems to me it would be a mistake sealing between the cap and block because that rear bearing would sit looser. I...
  3. P

    R.D.F. what's this starter fit

    starter nose three bolt no. 1940321 starter 1113080 thanks off 336 engine
  4. J

    E-3 COOP Not hitting

    I have a E3 Coop that was running OK, but now it is only hitting on about 2 cylinders. I have checked all the plugs and they seem to look fine. I also have a spark tester, and there is spark going to each plug. Any theories as to why it isn't hitting like it should?
  5. 5

    volt meter adjustment on Ford F150 1991

    Is there an adjustment to calibrate the voltmeter on my Ford truck 1991 F150. Measuring voltage (with quality Fluke meter) right at the battery terminals gives me 14 volts. Center point of the dash voltmeter is 13 volts and the voltmeter pointer reads below that at about 11.5 to 12 volts...
  6. J

    Case power shift

    Agri King We have tryed turning the planetary but it does not want to come appart. Thanks john
  7. J

    Case power shift

    No we have not i can not see any to remove. Where should they be at? Are they under the 3 plugs in the planetary ring gear? thanks john
  8. J

    Case power shift

    I removed the C2 and C3 unit out of a case 870. I can not get the planatary appart can anyone help? I added some images i hope they load but they might be able to help you see what im trying to do. http://www.flickr.com/photos/26425119@N00/8525845359/ http://flic.kr/p/dZpbag...
  9. J

    Case 870 powershift disassembly

    I can not get the C2 and C3 clutch and planetary unit appart. I did not know what to do next i have a book and it wants me to remove the power drive staft and the planetary unit from the planet carrier. I dont know how to do this because i have the shaft out but the planetary is not moving...
  10. J

    Case 870 powershift disassembly

    I"m trying to disassemble the C2/C3 clutch unit. I need to remove the snap ring on the output gear that drives the range transmission according to the shop manual, but cannot seem to get the ring out of the groove. Any advice is appreciated
  11. J

    case 1690

    Thank you i did not pay alot for it so it was a good buy.
  12. J

    case 1390

    No it is all one cover on the head and it is only a 4 cylinder tractor. with alot of black smoke!
  13. J

    case 1390

    I am not running any turbo but i would like to put a case 1490 turbo on it. the fuel pump is just turned and that is all.
  14. J

    case 1690

    Thank you for some help do you think this was a good buy or a bad one.
  15. J

    case 1390

    Thanks a case 1390 has a Displacement of: 219 ci [3.6 L] and it only has about 60 horse power we were pulling in a 9500 lbs class. so it does very good for its size. http://www.external_link/farm-tractors/000/5/2/523-ji-case-1390.html This is a page that you can learn more about it if you...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top