Recent content by johnarlyce

  1. J

    wiring problems on Super C

    That is the main problem right now! The wiring...The gentleman that I got the tractor from didn't quite put the wiring in correctly as far as i can figure out. Before I let the alternator man change this one over to a one wire alt, it had 4 wires. Main charging wire consisted of two running...
  2. J

    wiring problems on Super C

    Are you talking about the battery neg post to a bolt that holds the starter on? Just wondering. Would it be alright to email you with information I have? John
  3. J

    wiring problems on Super C

    the tractor quit running about three weeks ago. I'm digging into my wallet weekly trying to figure out what the problem-problems are. Rebuilt starter, new 6-volt coil, new starter push-in button, one side pos.side of battery connects to, the other side cable runs down to starter, points fine...
  4. J

    wiring problems on Super C

    so is the positive side of the ammeter the load side. It is marked with a -sign and a +sign? Thanks for your previous reply. Points me in the right direction anyway!
  5. J

    wiring problems on Super C

    I had my alternator changed from a three wire to a one wire. I guess I should have left it alone. On the 3-wire setup, there was main post and tabs A & B. B tab wire was a charging wire. A tab wire was sandwiched between two 10 gauge wires that were located on main post of alt. The...
  6. J

    1951 super c converted to 12 volt sys. won't start

    Carb. specialist said there might be same issues you spoke of: dirt or trash blocking needle open, float not set right. It ran okay until i was pushing snow and it just stopped and hasn't started since. Next i'll clean out bowl screen and see what happens. Thanks, John
  7. J

    1951 super c converted to 12 volt sys. won't start

    the alt. was a 3-wire. Starter/alt. guy added a something inside alt. to where the alt. would start charging as soon as motor started. should i pay again to have the 3- back? Main post has two wires, one to amp meter, one to on/off switch. that's it. no other wires. The cable wire going...
  8. J

    1951 super c converted to 12 volt sys. won't start

    One wire coming off alt. goes to amp meter, the other wire that is connected to the same post on the alt. goes to the on/off pull out switch and the lights. It was a three, two common wires i just spoke of, one wire that went to tab on alt., and one charging start wire coming off the other tab...
  9. J

    1951 super c converted to 12 volt sys. won't start

    I have new starter push-button switch. New one wire alternator that has two white wires running from alt. to starter pull-out switch, etc. New 12-volt coil. It appears that something is drawing the battery strength down swiftly when trying to start the tractor. 650 CCA battery. Do you have a...
  10. J

    idle adjustments

    thank you
  11. J

    idle adjustments

    1951 Super C that has been converted to a 12 volt system. The alternator has one wire running to the post that is located higher up in the back of the alt. with two other wires that run to the ammeter and ignition. The two wires running from the tab type connectors are what is a little...
  12. J

    idle adjustments

    I was recently informed by a forum member that alt. speed must reach 2000 rpm's to engage alt. charge. The only way I can figure out how to get to that is by manually pulling back governor rod. How can i increase idle speed if idle ajustment screw doesn't do anything? [/i][/b]
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top