(800) 853-2651
SHOP NOW

Recent content by johndeerefarmer

Yesterday's Tractor Forums
  1. J

    Traile ramps Mega vs monster vs max

    I have a 32' tilt deck trailer now. Already had two instances where the trailer wouldn't tilt. So it's either buy and carry a spare pump and hose or get something else. I also don't like loading the tilt deck. The nose of the tractor is way off of the ground. I would much prefer a 5' dovetail...
  2. J

    Traile ramps Mega vs monster vs max

    Looking at a new gooseneck trailer and am interested in the mega/monster/max ramps as I like the idea of a flat deck if needed and the wide ramps. If you have any one of these brands (Big Tex Mega, PJ Monster or Load Trail Max) give me a review. I need ramps that are easy to flip up and down...
  3. J

    620 fuel bowl and new lines

    Thanks, I have Sil Foss and brazing rods so it should be easy to move the ends over to the new line.
  4. J

    620 fuel bowl and new lines

    I have a new fuel bowl with shutoff to install. I will have to probably make a new fuel line. What size is it? Where can I get one? local NAPA? What do you recommend for a bender? Thanks
  5. J

    620 fuel shut off valve

    Got if figured out and about as close to the stock look as you can get. Got the parts at Home Depot.
  6. J

    620 fuel shut off valve

    Thanks. That would work but I prefer to keep it more original looking by mounting the shutoff at the fuel bowl
  7. J

    620 fuel shut off valve

    It has the original fuel bowl on it
  8. J

    620 fuel shut off valve

    I need a fuel shut off valve for my 620. Can't find anything 5/16" OD. What kind of valve or fitting did you use? Thanks
  9. J

    Mavel Schebler soft plugs

    Thanks for the responses. I will check them out
  10. J

    Mavel Schebler soft plugs

    Howdy I am rebuilding my DLTX-94. I removed all of the soft plugs to clean the carb but then find that my rebuild kit doesn't have all of the plugs. I bought the basic repair kit from Steiner. It has a few plugs but not enough. Their advanced doesn't appear to have all of the plugs either...
  11. J

    Deere 620 holes in manifold

    Thanks Bob
  12. J

    Deere 620 holes in manifold

    Your manifold came from Abilene Machine? Their's is quite a bit cheaper than YT or Steiner. Are they all the same quality?
  13. J

    Deere 620 holes in manifold

    One of the holes is in the intake so it could have been sucking dirt in for a long time. I hope that since the exhaust leak was there next to it the exhaust gases were preventing too much dust from being sucked in. I just ordered a compression tester to check the rings though I hadn't noticed it...
  14. J

    Deere 620 holes in manifold

    The holes are into both the intake and exhaust as I can blow air through with my air compressor. The question is, is it fixable?
  15. J

    Deere 620 holes in manifold

    Hi, I pulled off my exhaust manifold to replace the gaskets and found two holes. Hopefully you can see the pix here h The smaller hole is connected to the exhaust side and the larger connects to the intake side where the carb mounts. I think I can braze up the smaller hole but not the big...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top