Recent content by JohnWayne

  1. H

    Farmall 140 LoBoy on photo ads today

    This message is a reply to an archived post by Mark Peters on December 31, 2008 at 16:55:14. The original subject was "Farmall 140 LoBoy on photo ads today". Mark: Two very simple things were done to that 140. He lowered the seat roughly 6" and set it back close to 6". The base of that seat on...
  2. J

    Timing on '55 850

    I checked compression last year when I bought it. I had all three cyl. within 4 psi. I can"t remember the exact reading... someting in the 120s or 130s. I replaced the coil today. Bypassed the resistor that was before the coil. Put new (metallic core)plug wires on & got it to idle pretty good...
  3. J

    Timing on '55 850

    Yep... When I started out with the light, I just kept seeing the word 'out' on the fly wheel. But then after I got it to idle down I started to see 25... then 20... then down to 15 @ about 650 - 750 rpm. I had a hard time keeping the rpms steady that low. but I just wasn't sure what degree I...
  4. J

    Timing on '55 850

    Guys... I set my timing tonight & she's runnin better. I just have one question on the degree reading on the flywheel. I had the smoothest idle @ about 650 - 750 rpm @ 15 degrees. So thats what I left it @. Is this ok? My manual says to set it @ 5 degrees while running @ 475 rpm. But I just...
  5. J

    Ford 600

    A good place to go to find out the specifics you are talking about... www.oldfordtractors.com click on "identify your tractor" tab on the left.
  6. J

    Replacing origional 6V coil

    Not that I know of... I just bought it last year. The guy I bought it from had a 12 V battery in it just to get it to start so he could sell it. So I put in a new 6V (+ to ground)970 cold cranking amps battery. I've checked timing, & compression...I've replaced the points, plugs, rotor, cap, and...
  7. J

    Replacing origional 6V coil

    what do I get? & where can I pick up an aftermarket local? Don"t I get a 6V coil without internal resistor? NAPA only carries one 6V & it has an internal resistor (part#IC7). My wire feeding my coil off the ignition goes through a resistor before it feeds my coil (I think). Does this mean I can...
  8. J

    E-85

    What's this E-85?? & where can I get some.
  9. J

    lead fuel additive in '55 850?

    Ya... I searched some old discussions. Guess I'll take it back to Checker and get something I can use. What about octane booster? Does that stuff help?
  10. J

    Help, what ford tractor is this?

    Info you're lookin' for is @ www.oldfordtractors.com. click on the "ID your tractor" link on the left. First # 6** - Four wheel utility type with adjustable front axle, 134 ci gas, LP-gas or 144 ci diesel engine second # *3* - Four speed transmission, no PTO Third # **0 Hundred series, '55 -...
  11. J

    lead fuel additive in '55 850?

    Do you guys run lead additive in your old gas tractors? ... Do you find ANY fuel additives to work well on a regular basis?
  12. J

    Generator output on 850

    Hey Fellas... When my 850 is running, I get a 1 volt DC reading right on the lugs on my generator with no wires hooked up. Is this sufficient to keep my 6 volt battery charged? Or, is it time to rebuild?
  13. J

    Timing on 850

    Hey Fellas... I was working with my distributor on my 850 today. I have heard that your distrib. can actually be off 360 degrees. Since I don"t have a timing light handy...Does anyone know if she"ll run with the distributor 360 degrees off? I can get her to start... but she"s ran real sluggish...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top