-
J
machining an 8n rear axle
I have a '49 rear axle shaft in my '52 8N. I was wondering if I could have a machinist weld and smooth down a friction ridge that would allow the 52's axle's inner seal to ride on. My concern is the heat from welding process might reduce the strength of the axle? Any ideas? thanks for all...- johnz
- Thread
- Replies: 6
- Forum: Ford 9N, 2N & 8N
-
J
inner rear axle seal on '52 8n
I'm confused, just pulled the right rear axle and noticed the inner axle seal doesn't have a machined surface on the axle to rest itself on. Is this normal? (it's the first time I've done this) thanks johnz- johnz
- Thread
- Replies: 2
- Forum: Tractor & Farm Talk
-
J
Inner oil seal of rear axle
Perhaps I'm dealing with a 'hybrid'. I pulled the right rear axle to check the bearings of my 'new' 8N, serial number 500798, and noticed the axle shaft does not have a machined surfaced for the inner oil seal to contact. The axle surface is uniformly rough throughout this area similar to other...- johnz
- Thread
- Replies: 0
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy