(800) 853-2651
SHOP NOW

Recent content by jongurley

Yesterday's Tractor Forums
  1. J

    Starter question need some advice. John Deere A

    Whats chance i damaged the starter itself? it sounded like it was fine when i turned the key on and it spun, i can' try the new contact switch first i guess and new battery. ?
  2. J

    Starter question need some advice. John Deere A

    Hey guys. I have a 49 model A john deere. I was trying to start it the other day on a weak battery and come to find out a crappy cable connection to the negative side of battery. I kept trying to start it like a idiot and something stuck or welded itself shut. when i turn on the ignition key the...
  3. J

    1949 John Deere G clutch slipping question?

    Hey guys, I was recently driving my G around the farm and with the hand clutch fully engaged the clutched seemed to be slipping bad. Is there a way to adjust it anymore as far as the disk go? The handle full engages so i would guess the clutchs need replacing or adjusting, what do you guys...
  4. J

    John Deere G Pto seal question, Drain fluid??

    Hey guys i have a 1949 Model G that needs the pto seal changed out, it is seeping alittle fluid.. I ordered a new seal and a gasket for the little housing with 3 bolts around the pto shaft.. Do i need to drain the rear end fluid to change the seal, will it start running out when i pull that...
  5. J

    John Deere G Oil filter cup and assembly needed.

    Got it from Richard Brown thanks guys.
  6. J

    John Deere G Oil filter cup and assembly needed.

    Here is some of the parts i need. in this old thread. I need everything but bottom washer by the nut, the nut and cover. I need all the other bottom plate, spring, spacer, snap ring etc. http://www.yesterdaystractors.com/cgi-bin/viewit.cgi?bd=jd&th=475197
  7. J

    John Deere G Oil filter cup and assembly needed.

    Hey guys. I was changing the oil in my 1949 G i just bought,, i pulled the oil filter bottom cup off and pulled it down with filter in it. well when i pulled the filter out of the bottom cup there is no spring or flat round plate that goes to the bottom of filter.. any idea where i can find...
  8. J

    1949 John Deere G , reduction gear???

    Hey guys. I am about to change the engine oil and tranny oil in a model G 1949 I just bought. I was curious I have read about a reduction gearhousing that holds about a quart or two of motor oil , I was curious if the G had this, I don't really see any where to add or drain of a reduction...
  9. J

    1949 John Deere G valve noise.

    Is clearance suppose to be .020 when hot or cold??
  10. J

    1949 John Deere G valve noise.

    Should they be done hot or cold and what is proper clearance?
  11. J

    1949 John Deere G valve noise.

    Bushog could you explain how to do with with a dial indicator? thanks.
  12. J

    1949 John Deere G valve noise.

    No sir not yet. do you or anyone know what the hot or cold clearance should be .. I know I need a manual but hadn't got one yet. is there a top dead center mark or just rotate engine over with starter until in between strokes.?? ?
  13. J

    1949 John Deere G valve noise.

    Hey guys I recently purchased a 1949 John Deere G and the valve area is making a loud ticking noise. doesn't sound to bad but noticeable. is there anything I need to check or not, or is this normal. tractor runs perfect. thanks.
  14. J

    Vinyl decals for John Deere G 1949, I just need two G decals

    Thanks. I got up with him this morning.
  15. J

    Vinyl decals for John Deere G 1949, I just need two G decals

    Any contact info? on Travis Jorde
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top