Recent content by Jprice554

  1. J

    1952 8N wont start after sitting 2 years.

    When I googled it, it said that it should have came from the factory with the resistor. Ill have to do some more digging under the hood and see if its well hidden.
  2. J

    1952 8N wont start after sitting 2 years.

    Ill pull the tool box out and see if its fallen behind it, its gotta be there somewhere.
  3. J

    1952 8N wont start after sitting 2 years.

    I did try to start it immediately after cutting the engine off. I cant remember off the top of my head is the engine cranked slow when it was hot or not. Ill have to check that again today. I saw my electrical connections were definitely dirty and need cleaning, but I dont see a ballast resistor...
  4. J

    1952 8N wont start after sitting 2 years.

    My next plan to this afternoon is to check and clean all of my wiring connections, as well as check my points. Then compare my cold start voltage and readings to my hot start readings. I also cant seem to find the ballast resistor, I looked everywhere under the hood and I dont see one, my...
  5. J

    1952 8N wont start after sitting 2 years.

    So just now, while I was checking voltage I dont know if I wiggled a wire or the tractor cooled down enough but I went and checked my spark again, and I have good strong spark and it fired but up and idled again. This is a big headache.
  6. J

    1952 8N wont start after sitting 2 years.

    I also have 6.4 volts at the key switch with the key off, with the key on I have 5.8 volts at the switch on both sides. I have 5.8 volts at the incoming side of the coil with the key on. And 4.7 volts at the incoming side of the coil while cranking over.
  7. J

    1952 8N wont start after sitting 2 years.

    So I ran it for over an hour, finials got it running. It ran great. I killed the engine and it would not start back, I checked for fuel and had good fuel, check compression while hot, had compression, I check spark and it was weak. I got the meter out and I have 1.7 ohms across the coil with the...
  8. J

    1952 8N wont start after sitting 2 years.

    So I ran it for over an hour, i killed the engine and it wouldnt start back up. Immediately checked fuel by pulling the carburetor drain, have a good constant fuel flow. I then pulled a spark plug amd check the spark, its weak so I took a meter and check the ohms acros the coil, I only have 1.7...
  9. J

    1952 8N wont start after sitting 2 years.

    So I confirmed I had proper voltage to an through the coil, I checked the points again and they are still set the same way as when I set them originally. I did a compression test. I had great spark when I checked it but the plugs were dry again. So I pulled the carb and took it back apart and...
  10. J

    1952 8N wont start after sitting 2 years.

    Just did a compression test, Im at 82 on cylinder 1, 85 on cylinders 2 and 4, and 90 on cylinder 3. That doesnt seem too low
  11. J

    1952 8N wont start after sitting 2 years.

    So eh at a your opinion o what might be causing the intermittent spark? Sometimes I have excellent spark, sometimes I have weak spark.
  12. J

    1952 8N wont start after sitting 2 years.

    Ill try that next and check all my connections, also going to do a proper compression test to be sure.
  13. J

    1952 8N wont start after sitting 2 years.

    I read to set the spark plug gap at .025-.028 is that correct? Also I read to take an old plug and set it to 1/4 inch gap and see if it had enough spark to jump the gap in open air as a way to test the spark. This is my first time with an 8N so Im green around the gills here.
  14. J

    1952 8N wont start after sitting 2 years.

    The plugs are dry when I try to crank it normally, after I pulled them and dried them and tried to crank it without any assistance they were still dry, but the carb is sucking hard enough to pull my hand tight to the inlet so I figure it should suck starting fluid in or gas in a spray bottle...
  15. J

    1952 8N wont start after sitting 2 years.

    Whats the best way to do an ATF treatment? I havent had much experience with stuck rings, I plan to do a compression test today as well to confirm.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top