-
Jjtgaff replied to the thread 1969 jd400 tlb no brakes.My first go around was to put the ball in and Peen the hole smaller with a center point punch to hold the ball in. That lasted about 9...
-
Jjtgaff replied to the thread 1969 jd400 tlb no brakes.I do not remember, I do remember the edge of the hole was a very tight fit as if it was 'Peened" or closed off some, after the ball was...
-
Jjtgaff replied to the thread 1969 jd400 tlb no brakes.I had an issue with a JD 300 a few years back the following was the solution, I tapped and plugged the hole Re: JD 2020 Brake...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy