Recent content by jtgaff

  1. J

    1969 jd400 tlb no brakes

    My first go around was to put the ball in and Peen the hole smaller with a center point punch to hold the ball in. That lasted about 9 months, I then tapped and plugged the hole, no issue since.
  2. J

    1969 jd400 tlb no brakes

    I do not remember, I do remember the edge of the hole was a very tight fit as if it was 'Peened" or closed off some, after the ball was installed. With the assemble removed, is it possible to fill the reservoir from the top, then hand push the foot peddle to see where the fluid exits through a...
  3. J

    1969 jd400 tlb no brakes

    I had an issue with a JD 300 a few years back the following was the solution, I tapped and plugged the hole Re: JD 2020 Brake Problems in reply to David Ingle, 07-17-2006 17:05:21 Just finished getting the brakes working on a JD 400 (same as a 2020). If you remove the brake assembly off...
  4. J

    JD 300

    Thanks this is what I needed yes, Ind 300 sorry for lack of detail
  5. J

    JD 300

    I need a part number for packing / o-ring that seals oil pressure entry from main hydraulic pump to rock shaft assembly case. I looked on JD parts both for rock shaft assembly and transmission case. thanks
  6. J

    JD 300

    I have loader 7320 it has a different control valve. I found a picture of it on the JD parts, I do not know how to attach it to this post. the leaks are where # 10, and #33 on the diagram.
  7. J

    JD 300

    JD 300 Tractor with loader, T4W1D, serial #091770T, with a 7320 loader. The loader control valve has been dripping for some time, now is it leaking a steady stream. Are these re-buildable, or a replacement item. Where do I source another one, one with a "float" function. I believe I have a eight...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top